RUGGED RIDGE IS-EGTL-01 Euro Tail Light Guard Kit Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE IS-EGTL-01 Euro Tail Light Guard Kit Installation Guide
Assembly instruction
-
Remove the four Phillips head screws from the tail light lens.
-
Remove the tail light lens cover.
Note : Use caution as the lens may stick to the light housing. -
Remove the 3 tail light assembly retaining bolts
-
Remove the tail light housing from from the body
-
Carefully pull the tail light wiring through
-
Disconnect the tail light harness from the main harness the hole. Guide the connector through the hole
-
Guide the tail light wiring through the new Euro Tail Light Guard.
-
Re-connect the wiring connectors and guide the wiring back into the body.
-
Reinstall the tail light assembly and Euro Tail Light Guard to the original mounting holes using the new bolts provided.
-
Carefully guide the taillight lens back on to the tail light housing
-
Reinstall the four screws removed in step 1.
Caution : Be careful not to over tighten these screws. Over tightening will crack the lens.
Repeat steps 1-11 for the opposite side.
Check tail light operation. Installation of your New Euro Tail Light Guards is now complete
460 HORIZON DR. SUITE 400
SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
info@omix-ada.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>