Rugged Ridge IS-DBL-01 Dual Beam LED Light Instruction Manual
- June 13, 2024
- RUGGED RIDGE
Table of Contents
Rugged Ridge IS-DBL-01 Dual Beam LED Light Instruction Manual
Dual Beam LED Light
-
Wiring diagram for Dual Beam LED Light shown onright. Yellow wire powers amber running lamp. Red wire powers LED light. For detailed wiring diagram, see
Step 3 if using a Rugged Ridge two position switch or
Step 4 if using a Rugged Ridge three position switch. -
. Disconnect battery by removing negative terminal first, then positive
When removing battery cables do not touch positive and negative terminals togethe
Dual Beam LED Light
- Using two 30A relays and two position switches, wire relays and switches as shown
- Connect yellow wire (+12V IN) on Dual Beam LED Light to pin 87 (+12V OUT – A) on first
- Connect red wire (+12V IN) on Dual Beam LED Light to pin 87 (+12V OUT – B) on second
- Connect +12V IN from two relays to a properly rated fuse before connecting to power
- Connect +12V IN from two switches to power
- Ground all GND connections to the
- Reconnect battery
Dual Beam LED Light
- Using two 30A relays and one three position switch, wire relays and switches as shown
- Connect yellow wire (+12V IN) on Dual Beam LED Light to pin 87 (+12V OUT – A) on first
- Connect red wire (+12V IN) on Dual Beam LED Light to pin 87 (+12V OUT – B) on second
- Connect +12V IN from two relays to a properly rated fuse before connecting to power
- Connect +12V IN from switch to power
- Ground all GND connections to the
- Reconnect battery
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>