RUGGED RIDGE Front and Rear Aluminum Inner Fender Liners for Wrangler Instruction Manual
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE Front and Rear Aluminum Inner Fender Liners for Wrangler
PARTS LIST
| 1 | Driver/Left Front Fender Liner | 12 | 6mm Lock Washers |
|---|---|---|---|
| 1 | Passenger/Right Front Fender Liner | 12 | 6mm x 18mm OD x 1.6mm Flat Washers |
| 2 | L-Brackets | 2 | 6mm Clip Nuts |
| 12 | 6-1.0mm x 20mm Hex Bolts2 | 2 | 6mm Flange Nuts |
PROCEDURE
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY. ASSISTANCE IS RECOMMENDED.
-
Start installation on the Driver/Left side of the vehicle. Locate the factory bolt in the front of the wheel well, ( Figure 1 ). Temporarily remove the factory bolt. Select (1) L-Bracket. Reuse the factory bolt to attach the Bracket to the front of the wheel well, ( Figures 1 & 2).
-
Select (1) 6mm Clip Nut. Attach the Clip Nut to the front upper hole in the body panel, (Figure 3). NOTE: The threaded hole on the Clip Nut will need to face towards the vehicle.
-
Next, locate the (2) threaded holes in the upper wheel well, (Figure 4). Select the Driver/Left Fender Liner. Attach the Liner to the L-Bracket with (1) 6mm Hex Bolt, (1) 6mm Lock Washer and (1) 6mm Flat Washer, (Figure 5). Do not tighten hardware.
-
Attach the Liner to the Clip Nut with (1) 6mm Hex Bolt, (1) 6mm Lock Washer and (1) 6mm Flat Washer, (Figure 6). Do not tighten hardware.
-
Attach the Liner to the (2) threaded holes on the top of the wheel well with (2) 6mm Hex Bolts, (2) 6mm Lock Washers and (2) 6mm Flat Washers, (Figure 7). Do not tighten hardware.
-
Attach the Liner to the top threaded hole in the rear of the wheel well with (1) 6mm Hex Bolt, (1) 6mm Lock Washer and (1) 6mm Flat Washer, (Figure 8). Do not tighten hardware.
-
Locate the lower rear hole in the Liner and mark the body panel for drilling, (Figure 9). Temporarily remove the Fender Liner. Using a 1/4inch drill bit, (not included), drill the marked location. Select one 6mm bolt and insert into the drilled hole to ensure fit.
-
Reattach the Fender Liner and attach the lower rear hole to the drilled hole in the wheel well with (1) 6mm Hex Bolt, (1) 6mm Lock Washer, (1) 6mm Flat Washer and (1) 6mm Flange Nut, (Figure 8). Do not fully tighten hardware.
-
Level and adjust Fender Liner and tighten at hardware.
-
Repeat Steps 1—9 to attach the Passenger/Right Fender Liner.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used to clean the Fender Liners.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>