RUGGED RIDGE 30024 XHD Bumper Double X Striker Instruction Manual
- June 13, 2024
- RUGGED RIDGE
Table of Contents
30024 XHD Bumper Double X Striker
Instruction Manual
30024 XHD Bumper Double X Striker
Contents:
- Double X Striker
WARNING
To avoid serious injury: never exceed 6.5 ton working load on D-Ring mounts.
Use only to assist in vehicle self-recovery; never use DRing mounts as towing
point. Inspect before use. Replace if damaged or distorted. Striker Bar is not
to be used for towing or vehicle recovery.
- If Double X Striker is being added to an existing installation; remove D-Rings and/or any top or front mounted accesoires from center section. Center section should be sitting on frame rails but not attached.
- Place Double X Striker over center section and secure with 8 top bolts and washers (provided with center section). Do not tighten bolts.
- Install front 8 bolts and washers (provided with center section). Do not tighten bolts.
- Once all 16 bolts have been started, tighten the front 8 bolts, followed by the top 8 bolts. Installation is now complete.
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649
| EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
460 HORIZON DR. SUITE 400
SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
info@omix-ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>