RUGGED RIDGE 11548.20 Spartan Rear Bumper User Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
RUGGED RIDGE 11548.20 Spartan Rear Bumper
Product Information
The Spartan Rear Bumper, Full Width; JK & JKU is a component designed for off- road vehicles. It is manufactured by Omix-Ada, a company located in Suwanee, GA. The product is available in two different part numbers: 11548.20 and 11548.80.
The package includes the following components:
- Spartan Rear Bumper
- Mounting Bracket – Left
- Mounting Bracket – Right
- D-Shackle Tab (2)
- M12 Bolt – Long (8)
- M12 Flat Washer (8)
- M12 Bolt – Short (6)
- M12 Lock Washer (6)
- M12 Oversized Washer (6)
For warranty information, you can visit the official website of Omix-Ada: www .omix-ada.com.
Product Usage Instructions
- Remove the spare tire and factory rear bumper. It is recommended to have another person help lift the tire off the tire mount.
- Install the Left and Right Mounting Brackets into the frame rails using the short M12 Bolt, Lock Washer, and Oversized Washer. Do not fully tighten the hardware at this stage.
- Install the Spartan Rear Bumper and D-Shackle Tabs using the remaining M12 hardware. Align the bumper with the body and fully tighten the Mounting Bracket hardware.
- Reinstall the spare tire and torque the lug nuts to the factory specification.
Warning:
Failure to tighten the lug nuts to the proper torque specification could
result in serious injury or property damage.
Components
- Spartan Rear Bumper (1)
- Mounting Bracket – Left (1)
- Mounting Bracket – Right (1)
- D-Shackle Tab (2)
- M12 Bolt – Long (8)
- M12 Flat Washer (8)
- M12 Bolt – Short (6)
- M12 Lock Washer (6)
- M12 Oversized Washer (6)
Installation Instruction
-
Remove the spare tire and factory rear bumper.
CAUTION Have another person help lift the tire off the tire mount. -
Install Left and Right Mounting Brackets into frame rails using a short M12 Bolt, Lock Washer, and Oversized Washer. Do not fully tighten the hardware.
-
Install Spartan Rear Bumper and D-Shackle Tabs using remaining M12 hardware. Align bumper with body and fully tighten Mounting Bracket hardware.
-
Reinstall spare tire and torque lug nuts to factory specification.
WARNING
Failure to tighten lug nuts to proper torque specification could result in
serious injury or property damage.
Warranty
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com.
Contact Information
OMIX-ADA® TECHNICAL SUPPORT
- ADDRESS: 460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024
- PHONE: M-F 8am – 5pm EST 1-800-449-6649
- TICKET: www.omixsupport.com.
Copyright © 2017 Omix-Ada®, Inc.
References
- OMIX Jeep Replacement Parts - OEM & Vintage Aftermarket Jeep Parts | Omix
- Omix-ADA & Rugged Ridge Support System
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>