GENERATION LIGHTING 3175905 Summer 5 Light Chandelier Installation Guide
- June 13, 2024
- GENERATION LIGHTING
Table of Contents
990CH3175905-SUM
Installation Instructions for
Summer 5 Light Chandelier 3175905 1.1
CHANDELIER
GENERAL PRODUCT INFORMATION:
These fixtures are intended to be installed utilizing NEC compliant junction boxes.
This product is safety listed for damp locations.
Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
This instruction shows a typical installation.
CAUTION – RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.generationlighting.com
©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort &
Co. logo is a registered trademark of Visual Comfort & Co.
Visual Comfort & Co. reserves the right to change specifications for product
improvements without notification.
Install the Fixture
1A
A: JUNCTION BOX
B: SCREW COLLAR
C: CANOPY
D: COLLAR NUT
E: BOTTOM CUP
F: FIXTURE ARM
G: RING
H: PEG
I: LAMP
J: FINIAL
K: STEM
L: LINK AND LOOP
M: THREADED NIPPLE
N: MOUNTING PLATE
- Place the ring on to the pegs on the inside of each fixture arm. Be careful not to pinch the fixture wires.
- Place the bottom cup on to the fixture and secure with the finial.
- Determine the wanted height or look of the fixture with the provided stems and/or link and loop and assemble them by screwing them together. All the parts may be used alone or used in combination.
- Feed the fixture wires through the stems/chain and screw the assembly to the socket assembly.
- Unscrew the collar nut from the screw collar and place it onto the stem/chain followed by the canopy.
- Feed the fixture wires through the threaded nipple and screw the mounting plate assembly onto the stem/chain assembly.
- Align and secure the mounting plate to the junction box.
- Connect the fixture to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
- Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
- Neatly place all the wires into the junction box, place the canopy onto the ceiling, and secure it in place by screwing the collar nut tightly onto the screw collar.
- Screw the lamp into the socket. Refer to the label in the socket for Max Wattage Information.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>