RUGGED RIDGE JLU Body Armor Rocker Guard Kit Instruction Manual

: June 13, 2024
: RUGGED RIDGE

Table of Contents

RUGGED RIDGE JLU Body Armor Rocker Guard Kit
Product Information
Product Usage Instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RUGGED RIDGE JLU Body Armor Rocker Guard Kit

RUGGED-RIDGE-JLU-Body-Armor-Rocker-Guard-Kit-product

Product Information

Product Name: Body Armor, Rocker Guard Kit; JL & JLU
Part Numbers: 11651.61, 11651.62
Manufacturer: Omix-Ada
Address: 460 HORIZON DR. SUITE 400, SUWANEE, GA 30024
Contact Information:
Phone: 770-614-6101
Fax: 770-614-6069
Email: info@omix-ada.com.

Product Usage Instructions

Both sides of the vehicle’s lower rocker panels should be cleaned with soap and water up to the door line. Dry the surface with a clean cloth.
Rub the entire side with a promoter to remove any dirt and soap residue that may contaminate the adhesive tape used to secure the rocker guards. Allow the panel to dry.
Remove all 10mm bolts used to secure the front fender to the lower rocker panel.
Place the rocker guards into position. Do not remove the red liner at this time. Visually inspect the fit of the part to confirm that the mounting holes are aligned. Install bolts, washers, and lock nuts loosely. The rocker guard will hang away from the vehicle.
Peel the red liner from the back of the tape, working from the outer edges inward. Make sure that all tape covering is pulled back at the same time to ensure that all protective covering is removed during installation. Note: The help of a second person is recommended for this step.
Attach the rocker guard to the vehicle, keeping the part aligned to the vehicle’s surface. Apply pressure to ensure a strong bond. Tighten bolts and nuts. Note: The help of a second person is recommended for this step.
Repeat steps 1-6 for the opposite side of the vehicle.

Body Armor, Rocker Guard Kit; JL & JLU

Contents:

Right-hand Guard
Left-hand Guard
M6 Buttonhead Bolts (2Dr: 12pcs, 4Dr: 12pcs)
M6 Washers (2Dr: 24pcs, 4Dr: 24pcs)
M6 Hex Nut (2Dr: 12pcs, 4Dr: 12pcs)
3M Promoter

NOTE: These rocker guards have been designed to fit the contours of the vehicle. Instructions must be followed to ensure the correct placement and adhesion of this part. If the surface is not cleaned and prepared as stated below proper fitment will not take place. Do not install if the outside temperature is below 65F or above 100F. Allow the part to sit overnight before driving.

Both sides of the vehicle’s lower rocker panels should be cleaned to the door line with soap and water. Dry the surface with a clean cloth. Rub the entire side with the promoter. This will remove any dirt and soap residue that may contaminate the adhesive tape used to secure the rocker guards. Allow the panel to dry.
Remove all 10mm bolts used to secure the front fender to the lower rocker panel
Place rocker guards into position. DO NOT remove the red liner at this time. Visually inspect fit of the part to confirm mounting holes are aligned and install bolts, washers, and lock nuts loosely. The rocker guard will hang away from the vehicle.
Peel the red liner from the back of the tape working from the outer edges inward. Make sure that all tape covering is pulled back at the same time. This will ensure that all the protective covering is removed during installation.
NOTE: The help of a second person is recommended forthis step.
Attach a rocker guard to the vehicle keeping the part aligned to the vehicle surface. Apply pressure to ensure a strong bond. Tighten bolts and nuts.