RUGGED RIDGE JKU Magnetic Protection Panel Kit Instruction Manual

June 13, 2024
RUGGED RIDGE

OMIX-ADA, Inc.

Part #12300.53

460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix-ada.com

Magnetic Protection Panel Kit, JKU

RUGGED RIDGE JKU Magnetic Protection Panel Kit A1 RUGGED RIDGE JKU Magnetic Protection Panel Kit A2

4-Door Components
  1. Front Fender, LH (1)
  2. Front Fender, RH (1)
  3. Front Door, LH (1)
  4. Front Door, RH (1)
  5. Rear Door, LH (1)
  6. Rear Door, RH (1)
  7. Door Seam #1 (2)
  8. Door Seam #2, LH (1)
  9. Door Seam #2, RH (1)
  10. Door Seam #3, LH (1)
  11. Door Seam #3, RH (1)
  12. Rear Fender #1 (1)
  13. Rear Fender #2 (1)
  14. Rear Fender #3 (1)
To Install Magnetic Body Panels

1.Ensure area of vehicle and panels are clean by washing with a mild cleaning agent and air drying or drying with a soft cloth.

NOTICE Sub-zero temperatures may affect the strength of the Magnetic Body Panels. Installing Magnetic Body Panels in sub-zero temperatures is not recommended

2. Affix panels to vehicle as shown below. If panels need to be adjusted, remove entire panel and reapply. If trail badge does not match cutout in panel, remove badge and reapply to fit panel.

NOTICE Sliding Magnetic Body Panels on vehicle surface could cause scratching on vehicle surface or deformation of Magnetic Body Panels. To reposition, remove entire panels

RUGGED RIDGE JKU Magnetic Protection Panel Kit A3

Driver’s Side

OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649 | EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com

RUGGED RIDGE JKU Magnetic Protection Panel Kit A4

Passenger’s Side

Care and Maintenance

-Remove Magnetic Body Panels daily or after each use, especially if exposed to rain, mud, or other harsh conditions. Clean panels and vehicle and allow both to dry before reapplying.

-When not using Magnetic Body Panels, store in a clean, dry place, avoiding extreme temperatures. Storing in direct sunlight could cause damage or fading to the material.

-Store Magnetic Body Panels flat on a level surface to prevent warping or damage to the material. Do not allow magnetic surfaces to face one another.

Copyright © 2015 Omix-Ada®, Inc.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

RUGGED RIDGE User Manuals

Related Manuals