WYNDHAM COLLECTION WC-4141-36-SGL 36 Inch Single Vanity Instruction Manual

June 13, 2024
WYNDHAM COLLECTION

WYNDHAM COLLECTION WC-4141-36-SGL 36 Inch Single Vanity

Product Information

The product is a vanity cabinet with a counter and sink. It also includes a mirror and screws for the mirror. The handles for the cabinet are stored inside the vanity and need to be installed. The product requires professional installation and should be installed on a level surface. It is important to protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards.

Product Usage Instructions

  1. Check the received items against the Packing List and report any missing items to your retailer immediately.
  2. If required, adjust the hinges by following the instructions provided.
  3. Ensure you have the required tools not included in the box, including silicone sealant, a spirit level, a Phillips screwdriver, a tape measure, a pencil, and an electric drill.
  4. To install the handles, locate the box inside the cabinet and unpack the handles. Install them on the vanity without over-tightening.
  5. Use short screws for the door handles and long screws for the drawer handles.
  6. Install the counter by sealing around the top of the cabinet with clear silicone sealant. Allow it to dry for 24 hours for proper curing.
  7. To install the mirror, use a pencil to mark the placement of the screw holes on the wall. Drill the holes and insert the plastic wall anchors.
  8. Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror (approximately 1/4 – 1/2 inch).
  9. If required, adjust the drawer slides using the provided instructions for up and down adjustment, side adjustment, and depth adjustment.
  10. For additional detailed video instructions, scan the QR code provided with your phone or visit www.wyndhamcollection.com/3dslides.

Please note that the product also includes electrical outlets with a charging hub. It is easy to install and comes with a long 5-foot plug-in cord. The outlets are tamper-resistant and have a power reset switch. There are also 2 USB ports. It is important to use the product with ground-fault circuit interrupter (GFCI) outlets only and follow all applicable electrical codes.

Instructions

  • Prior to installation please check received items against the “Packing List”. Please report any missing items to your retailer immediately.
  • Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight and chemical hazards.WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-fig-1
  • Professional installation is recommended.
  • Please install it on a level surface. If minor door and drawer alignment is required, please follow the easy directions below.

WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-
fig-2

PACKING LIST

  • (Not all components may be included, depending upon your purchase)

WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-
fig-3

HOW TO ADJUST HINGES (if required)

WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-
fig-4

REQUIRED TOOLS NOT IN THE BOX

WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-
fig-5

INSTALLATION INSTRUCTIONS

  1. The handles are safely stored for transport in a box inside of the cabinet. Look inside the vanity for the box with your handles.WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-fig-6
  2. Unpack the handles and install them on the vanity. Do not over-tighten when attaching.WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-fig-7
  3. Short screws are for the door handles and long screws are for the drawer handles.WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-fig-8
  4. Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over apply. Allow to dry 24 hours for proper curing.
  5. Install the mirror: use a pencil to mark the placement of the screw holes on the wall, drill the holes and insert the plastic wall anchors.
  6. Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror – approx 1/4” – 1/2”.

HOW TO ADJUST DRAWER SLIDES (if required)

WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-
fig-12 WYNDHAM-COLLECTION-
WC-4141-36-SGL-36-Inch-Single-Vanity-fig-13

DIMENSIONS

Backboard Cutouts

WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-
fig-15

Note: All measurements are ± 1/4”.

Electrical Outlets with Charging Hub

  • Easy to install
  • Long 5-foot plug-in cord
  • 2 electrical outlets, 125V 15A
  • Tamper Resistant (TR) outlets
  • Power reset switch
  • 2 USB ports, 5V 2.1A Max
  • Use with ground-fault circuit interrupter (GFCI) outlets only
  • Residential use only
  • Follow all applicable electrical codes
  • ETL Listed
  • Conforms to UL Standard 962A
  • Certified to CAN/CSA Standard C22.2 No. 308

WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-
fig-16

Scan the QR code with your phone to watch detailed video instructions or visit www.wyndhamcollection.com/3dslides.

WYNDHAM-COLLECTION-WC-4141-36-SGL-36-Inch-Single-Vanity-
fig-14

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

WYNDHAM COLLECTION User Manuals

Related Manuals