WYNDHAM COLLECTION WC-4141-72-DBL 72 Inch Double Vanity Instruction Manual
- June 13, 2024
- WYNDHAM COLLECTION
Table of Contents
WYNDHAM COLLECTION WC-4141-72-DBL 72 Inch Double Vanity
Product Information
The WC-4141-72-DBL is a vanity cabinet with a counter, sink, and mirror. It is designed for residential use and comes with various features and components:
- Main Cabinet: 1 unit
- Counter & Sink: 1 unit (may not be included)
- Mirror: 1 unit (may not be included)
- Screws for Mirror: 2 units (may not be included)
- Packing List: Check all received items against this list and report any missing items to your retailer immediately
- Backsplash: Comes in two pieces
- Required Tools (not included): Silicone sealant, Spirit Level, Phillips Screwdriver, Tape measure, Pencil, Electric Drill
- Electrical Outlets with Charging Hub: Easy to install, long 5-foot plug-in cord, 2 electrical outlets (125V 15A TamperResistant), power reset switch, 2 USB ports (5V 2.1A Max), use with ground-fault circuit interrupter (GFCI) outlets only, conforms to UL Standard 962A, certified to CAN/CSA Standard C22.2 No. 308
Product Usage Instructions
Installation Instructions
- Open the vanity cabinet and locate the box containing the handles. Install the handles on the vanity, using the short screws for door handles and long screws for drawer handles. Do not over-tighten.
- Install the counter on top of the cabinet. Seal around the top of the cabinet with clear silicone sealant. Avoid over-applying the sealant. Allow it to dry for 24 hours.
- If required, adjust the hinges for minor door and drawer alignment. Refer to the provided instructions for adjusting hinges.
- If included, install the mirror on the wall. Use a pencil to mark the placement of the screw holes on the wall. Drill the holes and insert the plastic wall anchors. Install the screws into the wall anchors, leaving enough screws exposed to hang the mirror (approximately 1/4 – 1/2 inch).
Adjusting Drawer Slides (if required)
Refer to the provided WC-4141-72-DBL Installation Guide for detailed instructions on adjusting drawer slides. The guide includes information on up and down adjustment, side adjustment, and depth adjustment.
For further assistance, you can scan the QR code with your phone to watch a detailed video instruction or visit www.wyndhamcollection.com/3dslides.
Note: Professional installation is recommended for this product.
- Before installation please check the received items against the “Packing List”. Please report any missing items to your retailer immediately
- Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards.
- Professional installation recommended
- Please install it on a level surface. If minor door and drawer alignment is required, please follow the easy directions below.
- The backsplash comes in two pieces.
Overview
PACKING LIST
(Not all components may be included, depending upon your purchase )
(Not all components may be included, depending upon your purchase )
REQUIRED TOOLS NOT IN THE BOX
INSTALLATION INSTRUCTIONS
- The handles are safely stored for transport in a box inside of the cabinet. Look inside the vanity for the box with your hands.
- Unpack the handles and install them on the vanity. Do not over-tighten when attaching
- Short screws are for the door handles and long screws are for the drawer handles.
- Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over-apply. Allow to dry 24 hours for proper curing.
- Install the mirror: use a pencil to mark the placement of the screw holes on the wall, drill the holes and insert the plastic wall anchors.
- Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror – approx 1/4” – 1/2”.
HOW TO ADJUST DRAWER SLIDES
(if required)
- Scan the QR code with your phone to watch detailed video instructions or visit www.wyndhamcollection.com/3dslides.
Backboard Cutouts
Electrical Outlets with Charging Hub
- Easy to install
- Long 5-foot plug-in cord
- 2 electrical outlets, 125V 15A
- Tamper Resistant (TR) outlets
- Power reset switch
- 2 USB ports, 5V 2.1A Max
- Use with ground-fault circuit interrupter (GFCI) outlets only
- Residential use only
- Follow all applicable electrical codes
- ETL Listed
- Conforms to UL Standard 962A
- Certified to CAN/CSA Standard C22.2 No. 308
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>