GENERATION LIGHTING AW1161 Erro 14 Inch Tall Bathroom Sconce Instruction Manual
- June 13, 2024
- GENERATION LIGHTING
Table of Contents
**GENERATION LIGHTING AW1161 Erro 14 Inch Tall Bathroom Sconce
**
GP I : ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
This instruction shows a typical installation.
CAUTION RISK OF FIRE –
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS!
Install the Fixture
- Temporarily install the mounting plate to the junction box and mark the anchor locations through the holes on the mounting plate. Remove the mounting plate.
- Drill appropriate sized holes at the marked locations and install the anchors.
- Secure the mounting plate to the junction box.
- Screw the anchor screws into the anchors.
- Install the glass to the frames facing the proper direction using the corner screws. Install the felt pads where shown.
- Connect the fixture to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
- Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
- Neatly place all the wires into the junction box, place the fixture base onto the mounting plate, and secure using the fixture screws.
- Install the candle tubes by sliding them over the sockets.
- Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>