EZTRUNK Phantom JK JKU Aluminum Tube Doors Instruction Manual
- June 13, 2024
- EZTRUNK
Table of Contents
EZTRUNK Phantom JK JKU Aluminum Tube Doors
ASSEMBLY INSTRUCTION
WARNING This product is intended to provide added “off-road” convenience and utility to your vehicle.This product is not intended to provide occupant containment or protection in the event of an accident or rollover. Further, “on road” use may involve increased risk of serious injury in the event of side-impact accidents. To reduce risk from these types of injuries: Always wear seat belt and shoulder harness for all vehicle occupants.Keep arms and body inside vehicle. Drive safely, read and understand all manufacturers warnings and product instructions before installation. Periodically check and adjust all latches and fasteners, Failure to do so could result in the doors not latching securely.
- Attach the 2 door hinges to the new door using the 4 supplied M8x20 bolts and hardware. Leave the bolts snug only at this time, IMPORTANT INSTALL the longer pin hinge on upper position of door and shorter pin hinge on lower position. The upper hinge with longer pin ,which can be use to assist in guiding the door into place.
- CAUTION ! To avoid risk of injury latch mechanism must be properly adjusted before use. Inspect and adjust as necessary should wear alter alignment of latch and striker. Do not use door/latch if damaged.
- With the door closed, loosen the four screws from the hinges (using a #5 allen wrench and #13 open wrench), adjust door 2 directions position as needed and proceed to tightened the screws.
- Adjust the rubber stop so the doors do not move when driving. Turn the rubber to adjust. Adjust the 2 screws if needed.
CUSTOMER SERVICE: SERVICE@EZTRUNK.NET
Text & Call : 203-901-0055 / Call
203-591-9060
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>