SIGNATURE HARDWARE 946322 Brass P Trap User Manual

Table of Contents

SKU: 946322

The Bathroom Trap is a plumbing fixture designed for use in bathrooms. It is used to connect the drain of a sink or lavatory to the plumbing system. The trap helps prevent sewer gases from entering the bathroom and also allows for easy access to remove clogs or debris.
Before installing the Bathroom Trap, it is recommended to consult a professional if you are unfamiliar with plumbing installations. Signature Hardware accepts no liability for any damage or personal injury during installation. It is important to observe all local plumbing and building codes.
If you encounter any shipping damage upon unpacking the product, please contact our Customer Relations team via live chat at www.signaturehardware.com.or by emailing support@signaturehardware.com.

Getting Started

Before starting the installation process, make sure you have gathered all the required materials.

Additional Questions?

If you need further assistance or have any questions, please visit our Help Center at www.signaturehardware.com for product and warranty information. You can also contact us through live chat or by emailing support@signaturehardware.com.

Check that the pop-up drain is correctly installed according to its instructions.
Remove the inlet nut from the trap body and ensure the poly washer is inside the inlet nut.
Slide the tailpiece into the trap body, ensuring it is inserted at least 1 inch (2.5 cm) inside the inlet nut for proper compression fit.
With the threads facing down, slide the inlet nut with poly washer onto the tailpiece and hand-tighten it until it is flush against the trap body.
Remove the outlet nut from the trap body and ensure the poly washer is inside the outlet nut.
With the threads of the outlet nut facing toward the trap body, slide the outlet nut with poly washer onto the pipe, ensuring the pipe is inserted inside the trap body.
Hand-tighten the outlet nut until it is flush against the trap body.
Slide the wall flange onto the free end of the pipe and insert the pipe, then adjust the wall flange to cover the drain stub out.
Turn on the water supply to let water run through the drain and check for any leaks.

If you have any further questions or need assistance, please contact our customer support at 1.855.715.1800.

We recommend consulting a professional if you are unfamiliar with installing plumbing Fxtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage.
If any damage is found, contact our Customer Relations team via live chat at www.signaturehardware.com or by emailing support@signaturehardware.com.

Ensure that you have gathered all the required materials that are needed for the installation.

ADDITIONAL QUESTIONS?

Still need help? Check out our Help Center at www.signaturehardware.com for product and warranty information, or contact us through live chat or by emailing support@signaturehardware.com.

Check the pop-up drain is correctly installed to the lavatory according its instructions.
Remove the inlet nut from the trap body and check the poly washer is inside the inlet nut.
Slide the tailpiece into the trap body. To ensure a proper compression it, the tailpiece must be inserted at least 1” (2.5 cm) inside the inlet nut
With the threads facing down, slide the inlet nut down with poly washer onto the tailpiece and hand-tighten the inlet nut until the nut is fush against the trap body.
Remove the outlet nut from the trap body. Ensure the poly washer is inside the outlet nut.
With the threads of the outlet nut facing toward the trap body, slide the outlet nut with poly washer onto the pipe. Be sure to utilize the poly washer and the pipe must be inserted inside the trap body.
Hand-tighten the outlet nut until the nut is fush against the trap body
Slide the wall range onto the free end of the pipe and insert the pipe then adjust the wall range to cover the drain stub out.
Turn on the water supply to let water run through the drain for checking leaks.