baby trend TS06xxxC Passport Switch Modular Travel System Instruction Manual
- June 13, 2024
- baby trend
Table of Contents
Instruction Manual
Manual de Instrucciones Passport Switch Modular Travel System
TS06xxxC
with EZ-Lift™
35 PLUS
infant car seat
Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
TS06xxxC Passport Switch Modular Travel System
WARRANTY
DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND® FOR
REPLACEMENT PARTS, SERVICE AND REPAIR.
The Baby Trend® warranty covers workmanship defects within 1 year of purchase.
Any product which has been subjected to misuse, abuse, abnormal use, excessive
wear and tear, improper assembly, negligence, environmental exposure,
alteration or accident, or has had its serial number altered or removed
invalidates all claims against the manufacturer. Any damage to property during
installation is the sole responsibility of the end user.
Customer Service Department can be contacted at 1
800-328-7363 Monday through Friday
between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required
prior to returning product(s) to Baby Trend®. Please visit
http://babytrend.com/pages/ limited-warranty
for complete warranty details.
PARTS
Check that you have all the parts for this model before assembling the
stroller.
Please refer to the manual
located under the car seat for base type and instructions.
WARNING: Please follow all of these instructions to ensure the safety of
your child. Keep these instructions for future reference.
WARNING: Failure to follow these instructions could result in serious
injury or death. Avoid serious injury from falling or sliding out, always use
the safety harness and insure that the children are properly positioned
according to these instructions.
WARNING: Stroller is used for one child, always use the safety harness and
insure the child is properly positioned according to these instructions.
WARNING: Wheel can detach and cause tip over.
Pull on the wheel to assure it is securely attached.
WARNING: Care must be taken when folding and unfolding the stroller to
prevent finger entrapment.
WARNING:** Child may slip into leg openings and strangle. NEVER use in full
recline position unless the seat is in full recline and footrest buckle
released.
- CAUTION: This single stroller is designed for one child only. Use with more than one child may cause the unbalance condition which can injure/ harm your child.
- Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause a hazardous, unstable condition.
- ONLY the seat comes with this travel system can be used on the frame.
- The maximum weight that can be carried in the storage basket is 5 pounds (2.27kg).
- The maximum weight that can be carried in the cup holder is 1 pound (0.45kg).
- Be certain the stroller is completely opened and locked in place before allowing a child near the stroller.
- The combined maximum weight for the stroller is 50 lbs. (22.67 kg), including the child, storage basket, and cup holder. Do not exceed the weight limit. Additional weight on the stroller will cause excessive wear and stress and may cause a hazardous, unstable condition.
- The maximum weight for the infant car seat is 35lb (15.87kg).
- NEVER leave child unattended.
- NEVER use the stroller on stairways or escalators.
- NEVER use the stroller with roller skates, in-line skates, skateboards or bicycles.
- NEVER allow your stroller to be used as a toy.
- To clean use only mild household soap or detergent and warm water on a sponge or clean cloth.
- Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed.
- Discontinue use of stroller should it malfunction or become damaged. Please contact our customer service department to arrange for repair or obtain replacement parts.
ASSEMBLY
IMPORTANT! To ensure safe operation of your stroller, please follow these
instructions carefully. Please keep these instructions for future reference.
IMPORTANT! Before assembly and each use, inspect this product for damaged
hardware, loose joints, missing parts or sharp edges. NEVER use if any parts
are missing or broken.
IMPORTANT! Adult assembly is required. Keep child away during unpacking
and assembly.
Remove stroller from box. The front and rear wheels MUST be installed prior to
use.
FRONT WHEELS
To attach the front wheels, unfold stroller as described in the following
section:
-
• Unlock the fold latch (Fig. 1a) and unfold stroller frame by pulling upward on the stroller handle until the frame locks (Fig. 1b).
• Lean the stroller backwards. The front wheels must be facing backward to align the slot on the front wheel housing (Fig. 1c).
Push in the pin while inserting the front wheel until it locks into place (Fig. 1d).
NOTE: Pull on the wheel assembly to ensure that it is securely attached to the stroller.
REAR WHEELS -
• Attach the rear wheels onto the stroller frame until it clicks into place (Fig. 2).
NOTE: Pull on the rear wheel assembly to ensure that it is securely attached to the stroller.
BASKET
The rear basket needs to be installed prior to use. Pull the basket fabric under the bar before installing. -
• Insert the male ends of the rear basket frame into the female slots on the stroller frame until it locks into place (Fig. 3a).
• Always required: Secure the shorter straps with D-Rings around the bar underneath the rear axle as shown in (Fig. 3b). Thread each strap completely through the D-ring opening to create a loop. Ensure straps are secure to the bar before using the stroller.
• Detach the basket by pushing the button on each sides of the stroller frame and pull the basket out (Fig. 3c).
NOTE: Soft goods can be removed by sliding the fabric from the tube of the rear basket and removing the D-rings.
ATTACHING THE SEAT -
• Unfold the toddler seat fully (Fig. 4a).
• Insert both tabs of the toddler frame into the toddler seat fabric (Fig. 4b).
• To assemble the toddler seat, connect the lower tube into the inner slot of the seat frame, until it clicks into place (Fig. 4c). Repeat for the other side.
• Feed the strap through the tab to anchor the seat fabric on the seat frame, ensure the toddler seat is secured (Fig. 4d).
Repeat for the other side.
• Attach the seat by
lining up the seat anchors on the side of the seat with the anchors on the
stroller frame and pushing them together until they click securely (Fig. 4e).
The seat can face in either direction, frontward or backward.
• Carriage Mode: Make sure the buckle strap underneath the seat is loosend.
Then loosen the recline seat strap by squeezing the adjuster and pulling downwards (Fig. 4f). The carriage should be fully extended before using.
NOTE: The footrest area should be unbuckled (Fig. 4g).
BUMPER BAR
WARNING: Do not use bumper bar to lift or carry seat with child inside. The bumper bar is not a carrying handle.
WARNING- FALL HAZARD: Bumper bar is not designed to support a car seat, stroller may become unstable. -
• Attach the bumper bar by lining up anchors with the slots on the seat. Push until it locks into place (Fig. 5a).
NOTE: The bumper bar must be securely attached before using this product.
• To detach the bumper bar, press the release button on the bottom of the bar on each side, and pull bar out of the anchors (Fig. 5b).
TO ADJUST SEAT
WARNING: The upright position should be used only for a child that is at least 6 months old. -
• Toddler Seat Mode: The seat can be adjusted into an upright, reclined position. Push the center button on both sides of the stroller adaptor to rotate the seat (Fig. 6a).
• Rotate the seat into the desired position until it clicks into place (Fig. 6b). The seat can face in either direction, frontward or backward.
• Buckle the strap located underneath the seat (Fig. 6c). To tighten the strap, use the hook and loop method through the clip. Pull the strap firmly and attach.
NOTE: To adjust the recline seat strap,
squeeze the adjuster while pulling downwards or upwards (Fig. 6d).
PARENT PHONE HOLDER -
• To attach the parent phone holder: Slide the clip on the phone tab located on the stroller handle until it’s tightly secured (Fig. 7). To release, simply pull the parent phone holder upwards.
CUP HOLDER
WARNING: To avoid burns, never put hot liquids in a cup holder. Avoid possible tipping, do not place more than 1lb. (0.45kg) in a cup holder. -
• To attach the cup holder: Slide the clip on the cupholder over the cup holder tab on the handle bar. Push until firmly in place (Fig. 8).
REMOVABLE CANOPY -
• To attach the removable canopy: Slide the canopy clips on the inside of the corresponding slots on the stroller frame (Fig. 9a).
• Pull over the back of the canopy fabric to connect the three attachments located on the top of the seat frame (Fig. 9b).
• To open the canopy: Push forward on the front edge of the canopy while holding the rear of canopy in place (Fig. 9c).
• To fold the canopy: Pull backwards on the front edge (Fig. 9d).
• To remove the canopy: Press inward on both canopy tabs and slide the canopy up to remove (Fig. 9e).
SAFETY
BRAKES
WARNING: Always set brakes when the stroller is not being pushed so that
the stroller will not roll away. NEVER leave stroller unattended on a hill or
incline as the stroller may slide down the hill.
-
• To engage brakes, apply downward pressure to the rear of the brakes (Fig. 10a).
NOTE: Check that the stroller will not move once the brakes are properly applied.
• To release, apply downward pressure to the front of the brakes (Fig. 10b).
TO SECURE THE CHILD
WARNING: Avoid serious injury from falling or sliding out.
Always use the safety harness.
STRANGULATION
HAZARD: Child can strangle in loose straps. Never leave child in seat when straps are loose or undone. Type 1 -
• The shoulder straps of the 5-point harness have 3 attachment positions. Select the position that places the shoulder strap level with, or below the top of the child’s shoulder (Fig. 11a). To adjust harness height unhook the shoulder strap from the crotch buckle. Feed the shoulder strap through the harness spread slots. You can access these slots from the rear of the seat underneath the fabric. Feed shoulder strap through the appropriate slot and reattach the shoulder strap to the crotch buckle.
• Carefully place the child in the stroller seat and bring the safety harness around the child’s waist and over the child’s shoulders. Place the crotch strap between the child’s legs. Insert the male end of each shoulder/ waist belt into the buckle on the crotch strap. Tighten the harness so it is snug around the child’s waist and over the child’s shoulders (Fig. 11b).
TO RELEASE THE CHILD
Type 1 -
• To release, push the button on center clasp and the two harness buckles will pop free (Fig. 12).
-
• Unhook the shoulder straps only if adjusting the harness positions (Fig. 13).
TO FOLD STROLLER
WARNING: Care must be taken when folding and unfolding the stroller to prevent finger entrapment.
CAUTION: Do not allow children near stroller while folding.
OPTIONAL: The stroller can be folded with the seat (must be in toddler seat mode position) or without the seat installed. DO NOT remove the seat while child is inside. -
• Before folding the stroller, push the lower buttons on each side of the seat to disengage from the stroller frame (Fig. 14a).
• To fold the stroller, press the button on the left trigger, while pulling both release triggers simultaneously (Fig. 14b) and push the stroller handle toward the floor.
• Make sure the front wheels lie flat, then secure the stroller in the folded position by locking the fold latch, located on the right side of the stroller, over the rivet (Fig. 14c).
TO UNFOLD STROLLER
CAUTION: Do not allow children near stroller while unfolding. -
• Unlock the fold latch (Fig. 15a) and unfold stroller frame by pulling upward on the stroller handle until the frame locks (Fig. 15b).
INFANT CAR SEAT
THE INFANT CAR SEAT
WARNING: To avoid serious injury from falling, ALWAYS use the safety belt
to secure the car seat.
ATTENTION: CS01 EZ-Lift, CS02 EZ-Lift PLUS and CS03 EZ-Lift PRO Infant
Car Seats must attach to the module of the strollers front seat. These models
require child tray and seat back adjustment to the most reclined position.
NOTE: To make seat position adjustments refer to step 6d.
CS01 EZ-Lift, CS02 EZ-Lift PLUS and
CS03 EZ-Lift PRO Infant Car Seats
- • Align the car seat module to the inner frame connectors. Latch the module into the stroller frame. Underneath the car seats handle hub, carefully align it to the modular towers of the stroller frame. Press down firmly for the click. ALWAYS ensure that the car seat is properly connected and locked onto the stroller before each use by lifting up on the car seat handle(Fig. 16a).
REMOVING THE CAR SEAT: • NOTE: Set handle to the carry position (Fig. 16b). Squeeze the release handle located at the Toprear of the car seat and lift away from the stroller (Fig. 16c).
MODES
RIDING POSITIONS – 6 MODES
TODDLER SEAT MODE
Face in either direction, front or backwards. CARSEAT MODE
Face in either direction, front or backwards.
CARRIAGE MODE
Face in either direction, front or backwards.
MAINTENANCE
FRONT WHEEL REMOVAL
If adjustment or replacement is necessary:
- • Turn the front wheel backwards and locate the pin. Push the pin inside the wheel housing to remove the wheel(s) (Fig. 17).
CARE AND MAINTENANCE
SEAT PAD
-
To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth.
OTHER -
Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed.
MAINTENANCE AND CLEANING INSTRUCTIONS:
Use only household mild soap and warm water.
DO NOT USE BLEACH.
BABY TREND ®
CUSTOMER SERVICE
The Customer Service Department can be contacted
at 1 800-328-7363 Monday through Friday
between
8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are
required prior to returning product(s) to Baby Trend®.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos
reservados.
Baby Trend, Inc.
13048 Valley Blvd.
Fontana CA 92335
1-800-328-7363
(8:00 a.m. ~ 4:30 p.m. PST)
www.babytrend.com
TS06xxxC_2L_100422.1
References
- Limited Warranty Coverage – Baby Trend
- Baby Trend® | Car Seats, Strollers, High Chairs, Nursery and More!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>