Ciro3D G0157003 Goldstrike Throttle Wing Instruction Manual
- June 13, 2024
- Ciro3D
Table of Contents
Ciro3D G0157003 Goldstrike Throttle Wing
Product Information
The product is a Throttle Wing accessory manufactured by Ciro. It includes the following parts:
- Throttle Wing
- Cogg Ring
- M3 x 12mm SHCS (Screw)
Product Usage Instructions
- Park your motorcycle on a level surface and turn off the engine. If available, use the center stand to stabilize the motorcycle. Allow the engine to cool before proceeding with the installation.
- Using a 2.5mm Hex (Allen) Wrench, remove the screw at the end of the Goldstrike Grip. Keep the screw aside for reinstallation. Remove the end cap.
- Install the Cogg Ring onto the end of the Goldstrike Grip.
- Install the Throttle Wing using the provided 3mm screw. Adjust the angle of the Throttle Wing for comfort and tighten it securely. Avoid over-tightening.
Parts Included
- 1 THROTTLE WING
- 1 COGG RING
- 1 M3 x 12mm SHCS
Important:
- FIG.1: Refer to this diagram for visual guidance on removing the end cap and installing the Cogg Ring.
- FIG.2: Refer to this diagram for visual guidance on installing the Throttle Wing.
Warnings and Notices:
- WARNING: Ignoring the contents described herein can result in potentially serious injury or death if not followed.
- CAUTION: Ignoring the contents described herein can result in material damage and/or personal injury.
- ATTENTION: Ignoring this detail can affect the performance or functionality of the product.
It is recommended to have a competent mechanic install the product using standard mechanical procedures to ensure a safe and successful installation.
INSTALLATION INSTRUCTIONS
- Park on a level surface and shut off the motorcycle. Lift the motorcycle onto its center stand if available. Ensure the engine has time to cool before installation.
- Use a 2.5mm Hex (Allen) Wrench to remove the screw at the end of the Goldstrike Grip. Set aside the screw for reinstallation. Remove the end cap. (FIG.1)
- Install the Cogg Ring onto the end of the Goldstrike Grip.
- Install the Throttle Wing with the 3mm screw. Adjust the angle for comfort and tighten. DO NOT OVER TIGHTEN. (FIG.2)
WARNING:
This indication alerts you to the fact that ignoring the contents described
herein can result in potential serious injury or death if not followed.
CAUTION:
This indication alerts you to the fact that ignoring the contents described
herein can or will result in material damage and/or personal injury.
ATTENTION:
This indication alerts you to the fact if you ignore this detail you will
a˜ect the performance or functionality of the product. All Ciro products are
designed for “easy assembly” and/or “plug and play”. We recommend a competent
mechanic install our products, using standard mechanical procedures to assure
a safe and successful installation.
NOTE:
- Ciro products are designed and manufactured under very strict quality control. Ciro warrants that products sold to the original purchaser shall be free from any defects in materials and workmanship for a period of 3 (three) years from the date of purchase, and a lifetime warranty against LED failure.
- Ciro will have no obligation if the customer cannot show proof of purchase.
- Warranty will not be granted unless the part is properly installed and maintained.
- Ciro will not be liable for any consequential and incidental damages, including labor, or non-Ciro products.
- Please visit our website Ciro3d.com for our complete warranty policy.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>