Ciro3D 50410 Drink Holder with Perch Mount Instruction Manual

: June 5, 2024
: Ciro3D

Table of Contents

Ciro3D 50410 Drink Holder with Perch Mount
CIRO ACCESSORY PERCH MOUNT
CIRO DRINK HOLDER
Installation Instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Ciro3D 50410 Drink Holder with Perch Mount

CIRO ACCESSORY PERCH MOUNT

parts included

Perch Mount
Installation Kit
1/4-20 SHCS
M6 SHCS
Spacers

Park on a level surface and shut oﬀ the motorcycle. Ensure that the engine has time to cool before installation. Cover your tank with a clean towel or blanket to protect it.
Determine which side of the handlebars you would like the mount. Remove the two screws holding the clamp half in place. Carefully support the original clamp half and controls to prevent any accidental damage. (Fig. 1)
Compare the screws you removed to the screws included in this kit. Both 1/4-20 and M6x1.00 threaded screws are included to cover a variety of applications. Use the screws that match your motorcycle. Prepare the perch mount as shown above. (Fig. 2)
Install the perch mount with spacers to the motorcycle, making sure to re-use the original clamp half. Tighten to factory speciﬁcations; approximately 72-108 in-lbs (8.1-12.2 Nm). (Fig. 3)
The position of the top ball can be adjusted to provide adequate clearance for any installed accessory. Use a 5/32” hex key to loosen and adjust the position, checking ﬁnal tightness before riding. (Fig.4)

If you have purchased any Ciro accessories to go with your ball mount, please refer to those instructions to complete your installation.

WARNING:
This indication alerts you to the fact that ignoring the contents described herein can result in potentially serious injury or death if not followed.
CAUTION:
This indication alerts you to the fact that ignoring the contents described herein can or will result in material damage and/or personal injury.
ATTENTION:
This indication alerts you to the fact if you ignore this detail you will aﬀect the performance or functionality of the product.
All Ciro products are designed for “easy assembly” and/or “plug and play”. We recommend a competent mechanic install our products, using standard mechanical procedures to assure a safe and successful installation.
NOTE:
Ciro® warrants that products sold hereunder to the original purchaser, if maintained and operated under normal conditions, shall be free from any defects in materials and workmanship for a period of (3) years from date of purchase, and a lifetime warranty against LED failure. Ciro will have no obligation if the customer cannot show proof of purchase. Warranty will not be granted unless the part is properly installed and maintained. Ciro will not be liable for any consequential and incidental damages, including labor, or non- Ciro products. Please visit our website Ciro3d.com for our complete warranty policy.

CIRO DRINK HOLDER

parts included

Drink Holder Assembly

Installation Instructions

Remove the large plastic nut from your drink holder and slide it over The Ciro ball mount with The threads facing outward.
Snap your drink holder onto the ball and thread the large plastic nut back onto the drink holder. Adjust the angle, brighten it down, and you are ready To go.