GOLDEN LIGHTING 2122-5 MBS-BLK Reeva 5 Light Modern Brass Chandelier Ceiling Light Installation Guide

GOLDEN LIGHTING 2122-5 MBS-BLK Reeva 5 Light Modern Brass Chandelier

Ceiling Light

Product Information

The product is a lighting fixture manufactured by Golden Lighting. It is available in model number 2122-5 MBS-GE.

Product Usage Instructions

Pendants & Linear Pendants Above a Kitchen Island
Center a linear pendant over the kitchen island. If hanging pendants, use one pendant for every 24 inches of island. The fixtures should hang at least 30 inches above the countertop.

Colgantes y colgantes lineales sobre una isla de cocina
Centre un colgante lineal sobre la isla de la cocina. Si cuelga colgantes, use un colgante por cada 24 pulgadas de isla. Los accesorios deben colgar al menos 30 pulgadas por encima de la encimera.

Pendants & Chandeliers Above a Dining Room Table
The fixtures should stay at least 30 inches above the table. Use a fixture that is 12 inches narrower than the width of the table.

Pendants and Chandeliers in Open Areas
The bottom of the fixtures should hang at least 7.5 feet from the floor. Ensure there is enough clearance for any opening doors.

General Lighting Tips
To ensure the best lighting in your space, it is recommended to layer your lighting. This means using different types of fixtures such as sconces, flush mounts, and pendants to provide both task and ambient lighting. Install dimmers to control the level of light output at any given moment.

Note: For detailed assembly instructions and wire connections, please refer to the user manual provided with the product.

We hope you enjoy your new Golden Lighting product! For any further assistance or replacement parts, please contact the place of purchase.

For more information, lighting advice, and to browse coordinating lights, visit www.GoldenLighting.com.

Follow us on social media to share your love for your new light:

• Instagram: @GoldenLighting
• Twitter: @GLFixtures
• Facebook: @GoldenLighting

Thank You for Choosing Golden Lighting for Your Lighting Needs!

• Pendants & Linear Pendants Above a Kitchen Island
  Center a linear pendant over the island. If hanging pendants, use one pendant for every 24″ of island. Fixtures should hang at least 30″ above the countertop.

• Pendants & Chandeliers Above a Dining Room Table
  Fixtures should stay at least 30″ above the table. Use a fixture that is 12″ narrower than the width of the table.

• Pendants and Chandeliers in Open Areas
  The bottom should hang at least 7.5 feet from the floor. Allow clearance for any opening doors.

We appreciate your business and hope you love your new light!

Great lighting can add value and enhance the look of your home. To ensure the best lighting in your space, remember to layer your lighting. This ensures that your space will have both task and ambient lighting. Coordinating fixtures like sconces, flush mounts, and pendants can help you meet your layered lighting needs and reinforce your desired aesthetic. Install the lights with dimmers that allow you to control the level of light output at any given moment.
Get function and style! Browse our site for coordinating lights and expert lighting advice. To help create the perfect look, visit www.GoldenLighting.com.

Love your light and want to show it off?
Follow us, share a picture, and tag us on Social…

How to Identify the Fixture’s Wires

Hot: Smooth, Black, or Transparent with Black Inner Thread

Get help, quick tips, and explore curated content

For Customer Service, contact the place of purchase to arrange for replacement parts.

IMPORTANT:

• All installation work should be done by accredited professional.
• Shut off power supply at fuse or circuit breaker!
• Use only the specified bulbs. Do not exceed the maximum wattage!

Assembly Instructions

PREPARING FOR INSTALLATION
Carefully remove the new fixture from the carton as well as the yellow bag that holds all of the parts. See the important notes above. Shut off power
at the circuit breaker and remove old fixture from wall, including the old mounting strap. 1. From the parts bag remove the mounting strap (B) assembly. Mounting strap (B) contains several threaded holes. Two sets of mounting screws (A & D) should be attached to mounting strap (B). You may need to tighten nuts (C) that hold mounting screws (A) in place. If the screws are not attached, please hold canopy (F) up to mounting strap (B). Line up the holes in canopy (F) with the holes in mounting strap (B), insert mounting screws (A) into the holes in mounting strap (B) so that mounting screws (A) protrude through the holes in canopy (F). Mounting screws (A) are long, so please test the canopy against the mounting strap to see how far you should insert the screws. Tighten nuts (C) onto mounting screws (A) to hold the screws in place. 2. Pull house wires through the center of the mounting strap (B). Place mounting strap (B) over the junction box and secure in place with mounting screws (D). Tighten the screws securely with a screwdriver.

ASSEMBLING THE FIXTURE
If swivel (H) is separated from canopy (F), lock swivel (H) into canopy (F) using the hex nut that is at the top of swivel (H). Measure to determine the correct number of rods (I) needed for proper hanging height. To shorten the fixture, slide the desired number of excess rods off. If additional rods are needed, please contact the place of purchase to order more. Feed the fixture wires from post (J) through desired rods (I), swivel (H), and canopy (F). Pull the wires until taut. Thread together rods (I) to secure. Thread the bottom rod onto the nipple (J) Pull the wires until taut. Thread the top rod into swivel (H) to secure the rods (I) to the canopy (F). Trim the wires to the desired length plus 8 to 10 inches.

CONNECTING THE WIRES
Have an assistant support the fixture’s weight while completing the wiring. Refer to the wiring diagram and attach the fixture’s wires to the power supply wires from the junction box. Attach the fixture’s wires to the power supply wires from the junction box. Connect Hot to Hot (transparent wire with black inner thread, black, or smooth wire) Neutral to Neutral (transparent wire with white inner thread, white, or ribbed wire), and Ground to Ground (transparent wire with green inner thread, green wire, or copper). Twist the ends of the wire pairs together, and then twist on a wire connector. Make sure all twists are in the same direction. If there is no house ground wire coming from the junction box, locate ground screw (E) on the mounting bracket/mounting strap and wrap the fixture’s ground wire around the ground screw. Use a screwdriver to tighten the top of ground screw (E) onto the wires and into the mounting bracket/mounting strap. Tuck the wires into the junction box.

FINISHING THE INSTALLATION

Documents / Resources

| GOLDEN LIGHTING 2122-5 MBS-BLK Reeva 5 Light Modern Brass Chandelier Ceiling Light [pdf] Installation Guide
2122-5 MBS-BLK Reeva 5 Light Modern Brass Chandelier Ceiling Light, 2122-5 MBS-BLK, Reeva 5 Light Modern Brass Chandelier Ceiling Light, Brass Chandelier Ceiling Light, Chandelier Ceiling Light, Ceiling Light, Light
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>