WYNDHAM COLLECTION WC-1111-30-SGL Single Vanity with Optional Cultured Marble Counter Installation Guide

WYNDHAM COLLECTION WC-1111-30-SGL Single Vanity with Optional Cultured

Marble Counter

Product Information:

The product is a cabinet with a counter, sink, and mirror, designed for installation in a bathroom. It also includes screws for the mirror and a packing list. The cabinet is recommended to be installed by professionals and should be placed on a level surface. The surfaces of the product should be protected from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards. The product does not include all components in every purchase, so it is important to check the packing list and report any missing items to the retailer.

Product Usage Instructions

1. Before installation, check the received items against the Packing List and report any missing items to your retailer immediately.

2. Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards.

3. If minor door and drawer alignment is required, follow the easy directions below:

   • To adjust hinges (if required):
   1. Remove the handles from inside the cabinet doors and drawers.
   2. Reinstall the handles on the outside, ensuring not to over tighten.
   • To adjust drawer slides (if required):
   1. For up and down adjustment, refer to the WC-1111-30-SGL Installation Guide or scan the QR code with your phone to watch detailed video instructions.
   2. For side adjustment, refer to the WC-1111-30-SGL Installation Guide or scan the QR code with your phone to watch detailed video instructions.
   3. For depth adjustment, refer to the WC-1111-30-SGL Installation Guide or scan the QR code with your phone to watch detailed video instructions.

4. Install the product following these steps:

   • Install the counter, ensuring it is level.

   • Seal around the top of the cabinet with clear silicone sealant.
     Do not over-apply. Allow it to dry for 24 hours for proper curing.

   • Install the mirror by marking the placement of the screw holes on the wall using a pencil.

   • Drill holes on the marked positions and insert the plastic wall anchors.

   • Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror.

Required Tools (not included):

• Silicone sealant
• Spirit Level
• Phillips Screwdriver
• Tape measure
• Pencil
• Electric Drill

Note: For more detailed installation instructions and information, refer to the WC-1111-30-SGL Installation Guide or visit www.wyndhamcollection.com/3dslides.

Electrical Outlets Information:

The product also includes electrical outlets with a charging
hub. These outlets have the following features:

• Long 5-foot plug-in cord
• 2 electrical outlets, 125V 15A Tamper Resistant (TR) outlets
• Power reset switch
• 2 USB ports, 5V 2.1A Max
• Use with ground-fault circuit interrupter (GFCI) outlets only
• For residential use only
• Follow all applicable electrical codes
• ETL Listed
• Conforms to UL Standard 962A
• Certified to CAN/CSA Standard C22.2 No. 308

Note: For more detailed information about the electrical outlets, refer to the WWCC-2-9111219-3-800-S-GDLBL Installation Guide.

INSTRUCTION

• Prior to installation please check received items against the “Packing List”.
  Please report any missing items to your retailer immediately.

• Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight and chemical hazards.

• Professional installation recommended.

• Please install on a level surface. If minor door and drawer alignment is required, please follow the easy directions below.

PACKING LIST

(Not all components may be included, depending upon your purchase)

HOW TO ADJUST HINGES (if required)

REQUIRED TOOLS NOT IN BOX

INSTALLATION INSTRUCTIONS

1. Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over apply. Allow to dry 24 hours for proper curing.
2. Install the mirror: use a pencil to mark the placement of the screw holes on the wall, drill the holes and insert the plastic wall anchors.
3. Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror – approx 1/4″ – 1/2.
4. Remove the handles from inside the cabinet doors and drawers and reinstall on the outside. Do not over tighten when reattaching.

HOW TO ADJUST DRAWER SLIDES (if required)

Scan the QR code with your phone to watch detailed video instructions or visit www.wyndhamcollection.com/3dslides

Note: All measurements are ± 1/4”.

Backboard Cutouts

Electrical Outlets with Charging Hub

• Easy to install
• Long 5 foot plug in cord
• 2 electrical outlets, 125V 15A
• Tamper Resistant (TR) outlets
• Power reset switch
• 2 USB ports, 5V 2.1A Max
• Use with ground-fault circuit interrupter (GFCI) outlets only
• Residential use only
• Follow all applicable electrical codes
• ETL Listed
• Conforms to UL Standard 962A
• Certified to CAN/CSA Standard C22.2 No. 308

References

• wyndhamcollection.com/3dslides

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>