OPT7 Universal Fit Aura Pro Underglow For Car Installation Guide
- June 13, 2024
- Aura
Table of Contents
OPT7 Universal Fit Aura Pro Underglow For Car
COMPONENTS
RIGID LIGHT BARS
AURA BLUETOOTH CONTROL BOX
Y-SPLITTERS
HARDWIRE POWER HARNESS
INCLUDES – WIRE MOUNTS, SELF-TAPPING SCREWS, BOOSTER, VELCRO, ZIP TIES
MOUNTING KIT
INSTALLATION
STEP 1
Inspect kit to ensure all contents was included.
STEP 2
Decide where to locate the control box and ensure wiring has enough length
for light bars to be installed in desired location.
IMPORTANT
The control box must be installed inside the vehicle as it is not
waterproof. Avoid installation areas of the engine bay + heated surfaces.
EXAMPLES
The extension wires are on the led bar. Lay out the bars to measure the length prior to install for a successful installation.
2 x 48” LED Bar + 8ft extension wire
1 x 36” LED Bar + 18ft extension wire
1 x 36” LED Bar + 8ft extension wire
- Connecting to more than 10 AMP will override the kit and cause early failure, ensure it is 10AMPs or less!!
- Please ensure that the LED bars or strips/control box/wiring all are mounted in areas where will not exceed 85℃ or 185℉.
HOW TO CONNECT POWER HARNESS TO YOUR VEHICLE
- Connect the Red line(+) of power hareness to the vehicle battery’s positive terminal.
- Connect the Black line (-) of power hareness to the vehicle battery’s negative terminal or an unpainted area on your vehicle’s frame.
- Connecting to more than 10 AMP will override the kit and cause early failure, ensure it is 10AMPs or less!!
- Please ensure that the LED bars or strips/control box/wiring all are mounted WARNING in areas where will not exceed 85℃ or 185℉.
STEP 3
Scan the QR code on the back of the control box to download the app.
STEP 4
Secure Control box in desired location with Velcro or zipties.
- The control box is NOT waterproof. Tuck it away from the elements.
STEP 5
Secure the light bars using the zip ties to tie all the wiring away from
the moving components.
IMPORTANT
The LED connectors are not waterproof. You will need to use HEAT SHRINK
TUBE (not included) or ELECTRICAL TAPE around the LED connectors to ensure the
longevity of the lighting kit.
STEP 6
Open the “OPT7 Connect” App, pair your smart phone to the control box, and
pick your desired color!
AUX WIRING FOR A DOOR/DOME LIGHT
Please scan to see a detail instruction on Door Assist Sync or go to https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation-Guide
OPT7 CONNECT APP
- Colors
- Modes
- Door Assist
- Support
- Ability to control up to
- 4 devices at once
|
|
---|---|---
| 
Download the free “OPT7 CONNECT” App
- App iOS (12+) available on App Store
- Android (6 +) available on Google Play
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing
this product. The Installation Guide is intended as assistance to reduce setup
time. OPT7
Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7
Lighting will void product warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>