ATTICA ATTFB01A102-2-BX Terra Series Skid Plate Instruction Manual
- June 13, 2024
- ATTICA
Table of Contents
21-23 Ford Bronco
Terra Series Skid Plate
ATTFB01A102-2-BX
INSTALLATION MANUAL
CAUTION BEFORE INSTALLING
Before installation – Read and understand all instructions, warnings,
cautions, and notes contained in this installation instruction guide. Consult
your vehicle owner’s manual for proper disconnection of electrical and
lighting of vehicle if required for installation of this product.
This install may require some technical skills and knowledge of basic
mechanical work. If you do not feel that you are capable of performing this
install please take this product to a trained professional.
After reading this guide please contact us with any questions or concerns
before installing product.
Customer Service: 626-369-2121
ATTICA4X4 is not responsible for any bodily injury or harm to you or your
vehicle as a result of an improper install.
Proper installation of this kit requires knowledge of the factory recommended
procedures for removal and installation of original equipment components. We
recommend that the factory shop manual and any special tools needed to service
your vehicle be on hand during the installation. Installation of this kit
without proper knowledge of the factory recommended procedures may affect the
performance of these components and the safety of the vehicle.
Always wear eye protection when operating power tools.
Inspect all contents of this package to make sure product is not damaged and
all installation hardware has been included. If parts are missing from kit,
please be prepared to provide the following information:
- Name of purchase location
- Bar Code on side of box
- Date above Bar Code
- Date insde box cover
TOOLS REQUIRED
- 4mm hex socket
HARDWARE KIT
INSTALLATION
Begin by unpacking all items and inspecting them for damage or missing items. Any concerns, please contact the company you purchased the skid plate from.
After inspection, position the skid plate at the bottom of the bumper.
Installing each mounting point using W09 and W13 washers, and B07 bolts,
secure them using a 4mm hex tool.
Reuse your factory bolts for the rear mounting points.
Once finished, your Attica Terra Series Rear Bumper will be completely
installed and ready to take to the outdoors!
if you have any questions, please email us at tech@attica4x4.com or call us at 626-369-2121
tech@attica4x4.com
626-369-2121
13942 VALLEY BLVD, CITY OF INDUSTRY, CA 91746
TECH@ATTICA4X4.COM
626-369-2121
WWW.ATTICA4X4.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>