ATTICA ATTJL01A110-BX Frontier Series Front Bumper Instruction Manual
- June 13, 2024
- ATTICA
Table of Contents
18-23 Jeep Wrangler JL
Frontier Series Front Bumper
AT TJL 01A110-BX
tech@attica4x4.com
626-369-2121
CAUTION BEFORE INSTALLING
Before installation – Read and understand all instructions, warnings,
cautions, and notes contained in this installation instruction guide. Consult
your vehicle owner’s manual for proper disconnection of electrical and lifting
of vehicle if required for installation of this product.
This install may require some technical skills and knowledge of basic
mechanical work. If you do not feel that you are capable of performing this
install please take this product to a trained professional.
After reading this guide please contact us with any questions or concerns
before installing product.
Customer Service: 626-369-2121
ATTICA4X4 is not responsible for any bodily injury or harm to you or your
vehicle as a result of an improper install.
Proper installation of this kit requires knowledge of the factory recommended
procedures for removal and installation of original equipment components. We
recommend that the factory shop manual and any special tools needed to service
your vehicle be on hand during the installation. Installation of this kit
without proper knowledge of the factory recommended procedures may affect the
performance of these components and the safety of the vehicle.
Always wear eye protection when operating power tools.
Inspect all contents of this package to make sure product is not damaged and
all installation hardware has been included. If parts are missing from kit,
please be prepared to provide the following information:
- Name of purchase location
- Date above Bar Code
- Bar Code on side of box
- Date insde box cover
INSTALLATION MANUAL
tools required
- 13mm socket
- 16mm socket
- 4mm hex tool
hardware kit
Begin by unpacking all items and inspecting them for damage or missing items. Any concerns, please contact the company you purchased the bumper from.
After inspection, remove your factory bumper & winch.
First step is to mount the bull bar to the bumper.
The bull bar mounts to the bumper using B20 bolts, W16 and W19 washers and N22 nuts securing with 4mm hex tool & 13mm socket tool.
Insert B34 bolts and W21 plastic retainers onto the bumper as shown on the left.
To install the winch plate, use W22, W23, and W39 washers, winch plate spacers, and B25 bolts, securing them with a 16mm socket tool.
The winch plate spacer goes on the side, and the W39 washer goes in the front.
Attaching the front bumper onto your vehicle using W22,and W23 washers, and N25 nuts, securing them with a 16mm socket tool.
Once finished your Attica Frontier Series Front Bumper will be completely installed and ready to take to the outdoors!
if you have any questions, please email us at tech@attica4x4.com or call us at 626-369-2121
13942 VALLEY BLVD, CITY OF INDUSTRY, CA 91746
TECH@ATTICA4X4.COM
626-369-2121
WWW.ATTICA4X4.COM
tech@attica4x4.com
626-369-2121
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>