ATTICA ATTJL01A110-1-BX Frontier Series Front Modular Wings Instruction Manual
- June 13, 2024
- ATTICA
Table of Contents
INSTALLATION MANUAL
18-23 JEEP WRANGLER JL
FRONTIER SERIES FRONT MODULAR WINGS
ATTJL01A110-1-BX
CAUTION BEFORE INSTALLING
Before installation – Read and understand all instructions, warnings, cautions, and notes contained in this installation instruction guide. Consult your vehicle owner’s manual for proper disconnection of electrical and li ting of vehicle if required for installation of this product.
This install may require some technical skills and knowledge of basic mechanical work. If you do not feel that you are capable of performing this install please take this product to a trained professional.
After reading this guide please contact us with any questions or concerns
before installing product.
Customer Service:626-369-2121
ATTICA4X4 is not responsible for any bodily injury or harm to you or your vehicle as a result of an improper install.
Proper installation of this kit requires knowledge of the factory recommended procedures for removal and installation of original equipment components. We recommend that the factory shop manual and any special tools needed to service your vehicle be on hand during the installation. Installation of this kit without proper knowledge of the factory recommended procedures may affect the performance of these components and the safety of the vehicle.
Always wear eye protection when operating power tools.
Inspect all contents of this package to make sure product is not damaged and all installation hardware has been included. If parts are missing from kit, please be prepared to provide the following information:
- Name of purchase location
- Bar Code on side of box
- Date above Bar Code
- Date inside box cover
TOOLS REQUIRED
- 13mm Socket
- 13mm Wrench
HARDWARE KIT
x 16 x 8
W19 | Washer W16 | Washer
x 8 x 8
N22 | Hex Flange Nut B20 | Hex Head Bolt
x 1
SPARE PARTS HARDWARE KIT
Begin by unpacking all items and inspecting them for damage or missing items. Any concerns, please contact the company you purchased the front modular wings from.
After inspection, locate the mounting points on the Attica Frontier Series Front Bumper.
Mount the modular wings to the bumper using W16 and W19 washers, N22 nuts and B20 bolts with a 13mm wrench and a 13mm socket tool.
The front modular wing lights
connect to your headlight harness. Install the Attica inline headlight harness
adapter.
Next, connect the front modular wing light to the inline headlight harness adapter.
Once finished your Attica Frontier Series Front Modular Wings will be completely installed and ready to take to the outdoors!
13942 VALLEY BLVD, CITY OF INDUSTRY, CA 91746
[email protected]
626-369-2121
WWW.ATTICA4X4.COM
IF YOU HAVE ANY QUESTIONS, PLEASE EMAIL US AT [email protected] OR CALL US AT 626-369-2121
[email protected] 626-369-2121