StarTech P4DD46A2-KVM-SWITCH KVM Dual Monitor KVM Switch Instructions
- June 13, 2024
- StarTech
Table of Contents
P4DD46A2-KVM-SWITCH KVM Dual Monitor KVM
Switch Instructions
Product IDs
P2DD46A2-KVM-SWITCH
P4DD46A2-KVM-SWITCH
Product Information
For the latest software, manuals, product information, technical
specifications, and declarations of conformance, please visit:
www.StarTech.com/P2DD46A2-KVM-SWITCH
www.StarTech.com/P4DD46A2-KVM-SWITCH
Hotkey Commands
Hotkey commands are keystroke sequences that initiate computer/device functions and can be used to initiate KVM Switch functions. A hotkey command sequence must be initiated by the HK_LCode (HotKey Leading Code), followed by 1-2 additional keystrokes. Successful hotkey command inputs result in a high- pitch beep. Unsuccessful hotkey command inputs result in a low-pitched beep.
Notes:
- All keystroke combinations must be entered in rapid succession.
- Press and release the indicated keys, unless otherwise specified.
HK_LCode
Option 1.1
- Scr Lck + Scr Lck
Option 1.2
To change the HK_LCode:
- HK_LCode + H + Esc, Caps, or F12
- Alternatively, press and hold the front Host Selection Button for PC2, until 2 beeps are emitted, then press the desired leading hotkey of Scr Lck, ESC, Caps, or F12
| Hotkey Command | Function |
|---|
HK_LCode + 1 ~ 2 or
HK_LCode + F1 ~ F2| • Select PC 1 or PC 2.
HK_LCode + W| • Disable the binding between PC (USB/Video) and Audio when
switching between PC 1 or PC 2.
• Allows switching of PC Ports USB and Video functions, while Audio does not
switch
HK_LCode + Q| • Enable the binding of PC (USB/Video) and Audio switching.
• Audio will switch with the PC Ports USB and Video functions.
• Enabled by default.
HK_LCode + F5 ~ F6| • Audio Unbound: Selects only the audio and mic source
between PC 1 or PC 2, does not switch USB and Video
• Audio Bound: Select PC 1 or PC 2 and their respective USB/Video/Audio Ports
HK_LCode + Up Arrow Key
or
HK_LCode + Down Arrow Key| • Select the next/previous PC Port.
• If Audio is unbound, the audio will not switch
HK_LCode + B| • Disable the Beep that indicates HotKey Command Inputs.
HK_LCode + S| • Enable Autoscan.
• Press any key to stop the Autoscan function.
HK_LCode + H + “x”| • Define the Autoscan time delay.
• “x” = 1 – 10sec, 2 – 20sec, 3 – 30sec, 4 – 40sec, 5 – 50sec, 6 – 60sec, 7 –
70sec, 8 – 80sec, 9 – 90sec, 0 – 100sec
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and
more, visit www.startech.com/support.
Hotkey Command Revision: May 11, 2023