astro VETRO Instruction Manual
- June 3, 2024
- Astro
Table of Contents
astro VETRO Instruction Manual
EUROPE
PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE COMMENCING ASSEMBLY
Products with electronic ballasts must not be installed on the some electrical
circuits as products with inductive loads, for example magnetic fluorescent
luminaires, motors or ventilators. Inductive loads can generate excessive
voltage surges which can damage electronic ballasts.
The light source in this luminaire shall only be replaced by the manufacturer
or his service agent or a similar qualified person. Live: Normally Brown / Red
Neutral: Normally Blue / Black Earth: Normally Green / Yellow
This product contains a light source of energy efficiency class E to
Regulation (EU) No 2019/2015 (01/09/2021)
PLEASE READ THE INSTRUCTIONS CAREFULLY.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT
BRANCH CIRCUIT CONDUCTOR. THIS PRODUCT IS A CLASS 2 PRODUCT. THE REMOTE POWER
SUPPLY IS TO BE FITTED BY A QUALIFIED ELECTRICIAN AND LOCATED AWAY FROM THE
PRODUCT IN THE APPROPRIATE ENCLOSURE.
CONDUCTORS OF ANY SIZE ARE PERMITTED WHEN THE CONDUCTORS ARE IN CLASS 2 OR
EQUIVALENT ISOLATED LOW VOLTAGE, LIMITED ENERGY CIRCUITS ONLY AND ARE
PHYSICALLY SEPARATED FROM ALL OTHER NON-CLASS 2 OR NON-ISOLATED LOW VOLTAGE,
LIMITED ENERGY CIRCUITS, SUCH AS BY A BARRIER OR RELIABLY FIXED SPACING OF
MINIMUM 6.4 MM (0.25 IN).
DO NOT CONNECT LED DIRECTLY TO MAINS.
SUPPLY. DRIVER MUST BE USED.
PLEASE REFER TO THE “LED DRIVERS” GUIDE.
ALL ELECTRICAL CONNECTIONS MUST BE FULLY COVERED WITH INSULATING TAPE.
Installation Instructions
TURN OFF POWER
Not suitable for covering with thermal insulation.
Please refer to the “LED Drivers” guide.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>