WYNDHAM COLLECTION WC-5151-30-SGL 30 Inch Single Vanity Instruction Manual
- June 13, 2024
- WYNDHAM COLLECTION
Table of Contents
- WYNDHAM COLLECTION WC-5151-30-SGL 30 Inch Single Vanity
- Product Information
- Product Usage Instructions
- PACKING LIST
- HOW TO ADJUST HINGES (if required)
- REQUIRED TOOLS NOT IN BOX
- INSTALLATION INSTRUCTIONS
- HOW TO ADJUST DRAWER SLIDES (if required)
- Electrical Outlets with Charging Hub
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
WYNDHAM COLLECTION WC-5151-30-SGL 30 Inch Single Vanity
Product Information
The product is a WC-5151-30-SGL, which includes a main cabinet and a counter & sink (the sink may not be included, depending on your purchase). It is recommended to protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards. Professional installation is recommended. The product comes with a pre-cut backboard for ease of installation of hot and cold valves and drains. It also features electrical outlets with a charging hub, including 2 electrical outlets (125V 15A Tamper Resistant), a power reset switch, and 2 USB ports (5V 2.1A Max). The product is easy to install and comes with a long 5-foot plug-in cord.
Product Usage Instructions
-
Check the received items against the Packing List and report any missing items to your retailer immediately.
-
Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards.
-
Ensure the installation surface is level.
-
If minor door and drawer alignment is required, follow the easy directions on the next page.
-
Use the required tools not included in the box, including
silicone sealant, a spirit level, a Phillips screwdriver, a tape measure, a pencil, and an electric drill. -
For adjusting hinges (if required), follow the instructions provided.
-
Install the counter by sealing around the top of the cabinet with clear silicone sealant. Allow it to dry for 24 hours for proper curing.
-
Remove the handles from inside the cabinet doors and drawers and reinstall them on the outside. Do not over tighten when reattaching.
-
Plug in the electrical outlet and USB charging hub. For adjusting drawer slides (if required), refer to the provided instructions.
-
Follow the provided QR code or visit www.wyndhamcollection.com/alignment for detailed video instructions on installation.
-
Ensure proper use of the electrical outlets with the charging hub, including using ground-fault circuit interrupter (GFCI) outlets only, following all applicable electrical codes, and using the product for residential use only.
- Prior to installation please check received items against the “Packing List”.
- Please report any missing items to your retailer immediately.
- Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight and chemical hazards.
- Professional installation recommended.
- Please install on a level surface. If minor door and drawer alignment is required, please follow the easy directions on the next page.
PACKING LIST
(Not all components may be included, depending upon your purchase)
HOW TO ADJUST HINGES (if required)
REQUIRED TOOLS NOT IN BOX
INSTALLATION INSTRUCTIONS
Scan the QR code with your phone to watch detailed video instructions or visit www.wyndhamcollection.com/alignment
- CABINET ALIGNMENT GUIDE
- ALL cabinets are aligned, and metal trim is adjusted on a level floor before packaging.
- After shipping and reaching its destination, the cabinet doors and drawers may require minor alignment, depending on the condition of the floor where it will be installed.
- DO NOT move/adjust the door hinges or drawer glides before leveling/adjusting the cabinet on the floor.
- Start by adjusting the back two feet #3 and #4 by bringing the cabinet to a level position. Use a spirit level to ensure accuracy. After adjusting all four feet (front and back) check the metal trim alignment. After leveling the metal trim lines make sure all 4 vanity feet are firmly resting on the floor and the cabinet is perfectly level.
- By following the above instructions all the metal trim lines should now be aligned. Minor adjustment may be necessary by adjusting the door hinges and drawer glides, see How To Adjust Hinges on page 1, and How to Adjust Drawer Slides on page 4.
- Backboard is pre-cut for ease of installation for hot and cold valves and drains.
- Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over apply. Allow to dry 24 hours for proper curing.
- Remove the handles from inside the cabinet doors and drawers and reinstall on the outside. Do not over tighten when reattaching.
- Plug in electrical outlet and USB charging hub.
HOW TO ADJUST DRAWER SLIDES (if required)
Scan the QR code with your phone to watch detailed video instructions or visit www.wyndhamcollection.com/3dslides
Backboard Cutouts
*Note: All measurements are ± 1/4”.
Electrical Outlets with Charging Hub
- Easy to install
- Long 5 foot plug in cord
- 2 electrical outlets, 125V 15A
- Tamper Resistant (TR) outlets
- Power reset switch
- 2 USB ports, 5V 2.1A Max
- Use with ground-fault circuit interrupter (GFCI) outlets only Residential use only
- Follow all applicable electrical codes
- ETL Listed
- Conforms to UL Standard 962A
- Certified to CAN/CSA Standard C22.2 No. 308
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>