SOUL 8541796279 Hand Towel Ring Matte White Instruction Manual
- June 4, 2024
- SOUL
Table of Contents
8541796279 Hand Towel Ring Matte White
Instruction Manual
8541796279 Hand Towel Ring Matte White
ITEMS LIST (supplied)
- Wall Plugs
- Fixing Plate
- Screws
- Grub Screw
- Hex Key
YOU WILL NEED
- Spirit Level
- Drill
- 6mm Drill Bit
- Small/Tack Hammer
- Screw Driver
INSTALLATION INSTRUCTIONS
IMPORTANT
- Wall Plugs supplied with this product are only for the use of installation on solid walls (brick, masonry block, concrete etc).
- To prevent the drill from wandering on tiled surfaces it is recommended that masking tape be applied before drilling.
SOLID WALLS
- Mark and drill holes 6mm in diameter, and 40mm deep.
- IF multiple Fixing Plates (2) are in use, use a spirit level to ensure level.
- Insert the round end of Wall Plugs (1) into drilled holes and tap with a hammer until flush with the surface.
- Fit screws (3) through slots in Fixing Plate (2) before inserting into Wall Plugs (1).
- Tighten screws (3).
- Install accessory onto Fixing Plate/s (2), making sure that the Grub Screw (4) is located underneath as shown.
- With the accessory in place against the wall surface, tighten Grub Screw (4) using Hex Key (5) provided.
TILED CAVITY WALLS
(Plasterboard/tile, Fibre cement sheet/tile)
- Use appropriate Hollow Wall Anchors and M4 screws (not supplied) to replace Wall Plugs (1) and screws (3).
UNTITLED CAVITY WALLS
(Plasterboard, Fibre cement sheet)
- It is recommended that the accessory be screwed to a stud or noggin into the wall using suitable screws (not supplied).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>