JOOM VB803 Wireless Baby Monitoring System User Guide
- June 13, 2024
- JOOM
Table of Contents
JOOM VB803 Wireless Baby Monitoring System
Quick Start
NOTE : Use only the power adapters included in the package.
Status Bar
- Signal Strength Indicator
- Channel Selected
- Temperature Of The Baby’s Room
- Zoom Level
- VOX Function Active
- Alarm “Timer Active
- Current Time
- Battery Power
- PTT Function Active
- Pan & Till Function Active
- Backlighl Brightness Bar
- tilume Level Bar
Baby Unit
- Light Sensor
- Camera Lens
- Power LED Indicator
- Microphone
- ON / OFF Switch
- lnfared LEDs
- Speaker
- DC Jack IN
- Temperature Sensor
- PAIR Button
Parent Unit
- Antenna
- Brightness Buttons
- Volume Buttons
- Power ON / OFF/ Sleep Button
- Charging LED Indicator
- Lullaby Control Button
- Return Button
- Navigation Buttons
- Menu / OK Button
- Signal LED Indicator
- PTT Button
- ZOOM Button
- Microphone
- LCD Screen
- Volume Level LED
- Speaker
- Battery Compartment
- Kickstand
- DC Jack IN
PAIRING
The Baby Unit is pre-registered and connected to your Parent Unit.If you
need to pair Baby Unit and Parent Unit again, do the following:
Safety Instructions
- An adult is required to install. Keep small parts away from the children when assembling.
- This product is not a toy. Do not allow children to play with it.
- This baby monitor is not a substitute for responsible adult supervision.
- Do not place the baby unit or cables in the cot or within arm’s reach of the baby (at least 1 meter away).Keep the cords out of the reach of children.
- Do not use the baby monitor near water or a heat source.
- Only use the power adapters provided.
- Do not touch the plug contacts with sharp or metal objects.
- This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.
Specification
General:
RF Frequency:| 2400 MHz – 2483 MHz
Modulation Mode:| GFSK
Spread Spectrum:| FHSS
Operating Temperature:| -10 to +45°C
Operating Humidity:| <85%
Transmission Range:| Up to 1000feet in open field
Monitor:
LCD Display:| 5″ IPS LCD
Resolution:| 1280X720 pixel
Battery:| 3050mAh Li-ion 3.BV rechargeable
Duration(Screen ON):| 8 Hours (3 Level Led backlightl
Duration(Audio-only mode):| 16 Hours (3 Level volume)
Time To Full Charge:| 5 Hours
Power Adapter:| Input: 100-240VAC,50-60Hz; Output: 5V/1.2A ,Type C
Camera:
Sensor:| CMOS 1280X720 pixel
Vertical Turning Angle:| 90° up, 45° down
Horizontal Turning Angle:| 165° left, 165° right
Night Vison:| 8 IR LEDs
Power Adapter:| Input: 100-240VAC,50-60Hz; Output: 5V/1.2A,Type C
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>