BORMANN ban5040 Air nailer for crochet hook and fork User Manual
- June 4, 2024
- BORMANN
Table of Contents
ban5040 Air nailer for crochet hook and fork
BAN5040
017356
User Manual
Using the Tool
Power Source
- This tool applies to a normal air compressor and is designed to operate in clean, dry, and compressed air at regulating pressures between 4~7bar.
- Place two or three drops of air tool oil into the tool’s air inlet at the beginning of the workday and try it twice or three times.
CAUTION: Check and replace any damaged or worn components in the tool. The safety warning labels in the tool must also be replaced if they are not legible.
- Attach a high-flow pick connect fitting to the tool.
- Empty the cartridge.
- Connect the tool to an air compressor using the air hose. Made sure the hose has a rated working pressure exceeding 200Psi and a female quick coupler.
- Regulate the air pressure to obtain 4 ~ 7bar at the tool.
- Disconnect the air supply from the tool.
- Load the fastener into your tool following the instructions in this manual.
- Reconnect the air supply to the tool.
- Grip the tool firmly and hold the trigger while pushing the tool firmly against the work surface.
Lubrication and Maintenance
- Disconnect the air supply from the tool before lubricating.
- Your tool requires lubrication before you use it for the first time.
- Wipe off excessive oil at the exhaust. Excessive oil will damage the O-rings of the tool. If an in-line oilier is used, manual lubricating through the air inlet is not required on a daily basis.
- Turn the tool so the inlet is facing up hand put one drop of high-speed spindle oil. Never use detergent oil or additives. Operate the tool briefly after adding oil.
Clearing a Jammed Fastener
- Disconnect the air tool from the air hose.
- Pull back the pusher until it latches at the end of the cartridge.
- Remove Jammed fastener.
- Press the latch button and slide the pusher forward.
Technical Data
Required pressure: 60-100psi(4-7bar)
Nail Capacity: 100pcs
Dimensions: 55x235x255mm
Weight: 1.5kg(3.26Lb)
Nail length: 15-50mm(5/8″”-2″”)
- The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the products. The parts described/illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer’s product line with similar features and may not be included in the product you just acquired.
- Please note that our equipment has not been designed for use in commercial, trade, or industrial applications. Our warranty will be voided if the machine is used in commercial, trade, or industrial businesses or for equivalent purposes. To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair, or replacement work, including maintenance and special adjustments must only be carried out by technicians of the authorized service department of the manufacturer.
v2.1
Documents / Resources
|
BORMANN ban5040 Air nailer for crochet hook and
fork
[pdf] User Manual
ban5040 Air nailer for crochet hook and fork, ban5040, Air nailer for crochet
hook and fork, crochet hook and fork, hook and fork, fork
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>