GoHawk TJ4-Q/TN4-Q Powersports Amplified Stereo System User Manual
- June 6, 2024
- GoHawk
Table of Contents
TJ4-Q/TN4-Q Powersports Amplified Stereo System
User Manual
www.GoldenHawkUSA.com
714 5997709 (US)
Contents
| 4 x Speaker | 1 x Screw Kit |
|---|---|
| 1 x Amplifier | 1 x Screw Kit |
| 1 x Wired Control | 1 x Power Cord |
| 1 x Wired Control | 1 x Power Cord |
| 1 x AUX Cable | 1 x User’s Manual |
4 x Mounting Clamp
Features
- 4″ High-Performance Waterproof Speakers
- Support USB & SD Card input
- Built-In Bluetooth 5.0 for Audio Streaming
- 5mm AUX Input Jack
- Built-In FM Radio Receiver
- LCD Display
- All-Function Wired Remote
- Advanced Plating Process – Fade and Scratches Resistant
Read Before Installation
- The components and wiring should not be installed on or around any moving parts, keep away from ignition parts, fuel lines, engine or any hot exhaust.
- Speakers should not be installed where they might inhibit safety features on the vehicle such as lights, horns, brake levers, .
- Always test the speakers/amplifier prior to installation. Connect to the battery and play the music at least 3-minute to ensure the product is fully functional.
- Cutting rubber insert may be required for certain bar sizes.
- Splash, water and dust resistance are not permanent conditions and resistance might decrease as a result of normal wear.
- To avoid battery draining, disconnect the speaker from the battery if the motorcycle/AN is planned non-operation for more than 15 days.
- Engine, pipe and wind noise will overpower any speakers once it reaches certain speeds, it is physics and unavoidable.
- Please connect to a correct power supply (DC 12V)
Installation
Amplifier Installation:
This amplifier is not waterproof. It is required to install in a shaded
area to avoid rains and direct sunlight.
Wiring:
- Connect the speakers to 4, 5, 6, 7.
- Connect the antenna to 1 BT(Bluetooth) or 2 AT(Radio).
- Connect the wired control to 3.
- Plugin the power cord to the 8 DC power input and connect to a 12V battery. (Positive: RED, Negative: Black)
Functions and Controls:
Amplifier Panel:
| 9. CD Display | 13. USB Port |
|---|---|
| 10. Play/Pause, Mode(On/Off) | 14. Bluetooth Indicator |
| 11. Volume + / – | 15. SD Card Slot |
| 12. Previous / Next | 16. AUX-IN |
FCC NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on. the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>