Hcalory F20 Car Refrigerator Instruction Manual

Hcalory F20 Car Refrigerator

Before use, please do read these operation instructions carefully and keep them properly for later use

Safety Cautions

Warning!

• If there is any obvious damage to the icebox, please do not operate it.
• Please do not use pins, electric wires, etc to block the gap of the icebox.
• Please do not let the icebox get wet in the rain or immerse it in water.
• Please do not put the icebox near open fire or other heat sources (such as heaters, gas ovens, etc)to avoid direct sunshine.
• Please do not store flammable and explosive matters such as combustion supporting spray in the icebox.
• Ensure that the power cord is dry without damage. Please do not transfer the connection using several power sockets.
• Ensure that the supply voltage connected with the product will be proper at any time.
• Except the type of application recommended by the manufacturer, it is not allowed to use any electric product within the icebox container.
• After the icebox is unpacked, it is required to be placed for more than 6 hours before it is electrified.
• The icebox shall be placed horizontally during operation, with long-term operation inclination <5°and short-term operation inclination <45°.
• Maintain good ventilation around the icebox to facilitate heat dissipation (around the compressor <!:100mm).
• Stable and firm placement: The icebox shall be placed on the ground or in the vehicle in a stable and firm manner. When water is stored in the liner, do not invert the icebox to pour water.

Cautions!

• The installation and repair of the product shall be performed by professional repairers only. Improper repair may cause serious hazard. If service is required, please contact the repairers from the manufacturer.
• Installation of DC power in a ship must be operated by professional technicians.
• Children must be put under supervision when they are operating to ensure that they will not play with the icebox so as to avoid any unnecessary injury.
• f the device is unable to be used safely due to insufficient physical, sensory or mental abilities, or lack of expe­rience and knowledge, it shall not be used without supervision or guidance.
• Before discarding an old icebox, please check and close the icebox door to avoid children being trapped by mistake.

Prompt!

• Before cleaning and maintenance each time, the icebox’s power supply must be disconnected each time after use.
• Except the methods recommended by the manufacturer, mechanical equipment or other methods shall not be used to accelerate the defrosting process so as to avoid damaging the icebox’s circuit.
• Food shall be stored in the icebox in the original packaging as much as possible. Please set an appropriate temperature for the food or drug in the icebox.
• If the device is empty for long: turn off the device; defrost the device; clean and dry the device; open the cover to prevent the device from being moldy inside.
• This appliance is for home use and for other similar purposes:
  • Kitchen area in a store, office or other occasion;
  • Camp, farm and hotel, motor hotel and customer in an environmental environment;
  • Family hotel type environment;
  • Catering and other similar non-retail applications.
  • Proper disposal of the icebox: This icebox contains flammable refrigerant and thermal insulation foam layer, which should be recycled by a recycling factory.

Product Characteristics

• Highly efficient DC compressors and conversion modules are used, with high reliability and long service life;
• The fluorine free insulation layer is used with good heat preservation and low energy consumption;
• DC12/24V or AC100~240V is used (using dedicated adaptor);
• The refrigeration can be up to -20°C minimum (with the test ambient temperature as 25°C);
• The smart automobile battery protection system is used to take care of your car battery;
• Power disconnection memory function: Turn off the unit and pull off the power supply. When it is used next time, the icebox will run in the state previously set.

Diagram of Parts

1. Sealing strip
2. Storeroom
3. Control panel
4. Handle
5. Power input
6. Compressor compartment

Diagram of Parts

Two doors can be exchanged. If required, please operate in the following steps:

Functions and Operation

• Power supply:
  It can be connected with DC voltage 12/24V or AC voltage 100~240V (using dedicated adaptor);

• Display screen initialization:
  When power is connected, the buzzer gives a long tone, and the digital screen is fully on for 2 seconds, and then it enters the normal running mode.

• Power on/off:
  Connect the power, and shortly press the Power button for power on or off.

• Temperature setting:
  Shortly press the + or – button, and the temperature flashes and displays. Then press the + or – button to adjust the temperature. Long press it to be able to perform quick adjustment. After the screen stops flashing, the current temperature will be shown. If the adjustment range is big, some time will be needed to be able to reach the set temperature. The adjustable temperature range:-20~+20°C.

• Cooling mode setting:
  In the power on state, shortly press the Set button to switch to MAX (in the quick cooling mode) or ECO (energy saving mode).

• Battery protection setting:
  In the power on state, long press the Set button for 3 seconds. When the display screen flashes, then shortly press the Set button to select the battery protection levels H/M/L (high/medium/low). The factory setting is Level H (high) by default.

Form of voltage value reference

• The voltage value is a theoretical one, which may have some deviation.

When vehicle power supply is used, it is recommended that the battery protection be set as the high level. When the battery is externally connected or standby battery is connected, it is recommended that the battery protection be set as the medium or low level. After flame out of the vehicle motor, if the icebox can still run, it is required to regulate the protection mode to the high level. Otherwise, there may be too much consumption of vehicle’s battery power, which may render it unable to start the vehicle.

Cautions!
In the power off state, long press the Set button for 3 seconds, E1 displays, and press the Set button , it switches from E1, E2 … to E5. The screen flashes. Press the + or – to switch from degree centigrade °C to degree Fahrenheit.

Restore to factory settings
In the power off state, long press the Set button for 3 seconds, E1 displays, and long press the+ and – buttons simultaneously for 3 seconds, the screen is fully on, then the restoring of the factory setting is successful.

Commonly seen stored food and recommended storage temperature

Cleaning and Storage

Cleaning

• Turn off the unit, and remove the plug so as not to cause an electric fire;
• Use soft wet cloth to wipe interior and exterior surfaces, and then wipe it dry;
• Do not directly dip the icebox in water to be cleaned;
• Please do not use abrasive cleaning agents.

Storage

• If the icebox lies idle for long, please treat it in the following manner:
• Turn off the unit, remove the plug; and take out the items stored in the icebox;
• Use soft cloth to wipe the inside of the icebox dry;
• Put the icebox at a dry and well-ventilated place;
• Open the icebox a little bit to prevent the occurrence of odor.

Defrosting:

• After the icebox has been used for some time, the interior surface will have frost, which will reduce the refrigerating effect, and increase power consumption. Please defrost in the following steps:
• Turn the unit off, and remove the plug;
• Take out the items stored in the icebox;
• Open the icebox door and wait for the ice and frost to be melted;
• Use soft cloth to wipe it dry.

Do not defrost using sharp tools. Otherwise, it may damage the icebox.

APP Function Introduction and Bluetooth Connection

Reminder:
Click on the icon to lock or unlock the control panel of the icebox. If it is locked, then you can only use your mobile phone APP to control the icebox.

• Step 1:
  Activate the mobile phone Bluetooth, and then click on mobile phone APP, click on “Search” to search the icebox nearby.

• Step 2:
  Single click on the icebox icon to perform Bluetooth pairing (When it is the first time to connect the icebox, the applied program will give you prompt that you should press the Set button on the control panel of the icebox to pair the icebox). After pairing, the APP will switch to the main interface, and then you can control the icebox with your mobile phone.

Frequently Asked Questions

After-sale Service and Warranty

From the date of purchase, in the case of any quality trouble, the warranty period of the unit will be one year. The following circumstances will not be included in the free warranty:

• Artificial damage;
• Damage caused by force majeure events (such as earthquake or fire, etc).
• Failure or damage caused by failure to operate according to the cautions mentioned in the operation instruc­tions.
• Failure or damage caused by unauthorized dismantlement without permission of the manufacturer.

Technical Parameters

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>