swagtek 503719 5 inch 4G Smart Phone User Manual
- June 6, 2024
- swagtek
Table of Contents
ACCESSORIES:
QUICK GUIDE USER MANUAL
QUICK GUIDE
all tested frequency bands. Although the SAR Is determined at the highest
certified power level. the actual SAR level of the phone while operating con
be well below the maximum value. This is because the phone is designed to
operate at multiple power levels so as to use only the power required to reach
the network. In general, the closer you are to the wireless base station
antenna, the lower the power output. Before a phone model is available for
sale to the public, it must be tested and certified to the FCC that it does
not exceed the limit established by the government adopted a requirement for
safe exposure. The tests are performed in positions and locations (e.g.. at
the ear and worn on the body) os required by the FCC for each model. The
highest SAR value for this model phone when tested for use at the ear is 1366
W/Kg and when worn on the body, as described in this user guide. is L370W/Kg
(Body-worn measurements differ among phone models. depending upon available
accessories and FCC requirements). The maximum scaled SAR in hotspot mode is
1.370 W/Kg While there may be differences between the SAR levels of various
phones and at various positions. they all meet the government requirements en
rent for safe exposure. The FCC has granted an Equipment Authorization for
this model phone with all reported SAR levels evaluated as in compliance with
the FCC RFexpostre guidelines. SAR information on this model phone is on file
with the FCC and can be found under the Display Grant section of
http:J/www.fccgov/out/flaccid after searching on
FCC ID: 055503719 Additional information on Specific Absorption Rates
(SAR) can be found on the Cellular Telecommunications Industry Association
(CTIA) website at http://www.wow-com.com. • In the United States and Canada.
the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg)
averaged over one gram of tissue. The standard incorporates o sub-station
margin of safety to give additional protection for the public and to account
for my variations in measurements.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements. a minimum separation distance of 10mm must be
maintained between the user’s body and the handset, inducing the antenna
Third-parry belt-clips, holsters. and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1.) This device may not cause harmful
interference. (2) This device must accept any interference received. including
interference that may cause undesired operation a Changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device. pursuant to Port 15 of the FCC Rules These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can mob:4e radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception which can be determined by turning the equipment
off and on the user is encouraged to try to correct the interference by one or
more of the following measures: Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. Consult the dealer or an experienced radio/TV
technician for help.
SAR Information Statement
Your wireless phone is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radiofrequency
(RF) energy set by the Federal Communications Commission of the U.S
Government. These limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The guidelines are
based on standards that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies The standards
include a substantial safety margin designed to assure the safety of all
persons. regardless of age and health. The exposure standard for wireless
mobile phones employs a unit of measurement known as the Specific Absorption
Rate or SAR. The SAR limit set by the FCC is L6 W/kg. • Tests for SAR are
conducted with the phone transmitting of its highest certified power level in
Connect your Logic phone to the computer using the USB cable.
Copy music files from your computer to your Logic phone.
Install SIM card/memory card.
Get to know your Logic phone
Thank you for purchasing this innovative LOGIC device. The specifications in
this document are subject to change without prior notice.
LOGIC and the LOGIC logo are registered trademarks of Swagtek, Inc. Other
trademarks are the property of their respective owners.
Charge for 24 hours before using.
Warranty Certificate Tonne and Ccoclitlens
LOGC warrants that their products will be free from defects in material aid
worlanorshp The warranty period is one (1)year for the products and [three (3)
months for the accessories which are port of the °nand package indicting the
battery. The warranty period begins the date of purchase by the End-User who
shall present an invoke cc o purchase receipt when requiring warranty service
otherwise the warranty period will begin from the date of manufacture of the
product. LOGIC Val repel- a product without cost to the customer if it
presents o manufacturing defect or defect in workrncrrship during the warranty
period and if the defect occurred under ncrrnol conditions of use in exotica-
co with the instructions and specifications stated in the user’s manual
For additional information about the tannin and cal:lit: Ions of LOGIC’S
Limited Warranty or to obtain warranty service information. please visit the
support section at: logianablity.com
Iogicmobility.com
Made in China Copyright Swagtek. Inc. 2021
SHEET – BACK SIDE OPEN SIZE WITH BLEED: 100.33mm X 405.892mm
CLOSE FINISHED SIZE: 67.31mm X 95.758mm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>