ECHOMASTER HDCAMJW Jeep Wrangler JK AHD Night Vision Backup Camera Installation Guide
- June 13, 2024
- Echomaster
Table of Contents
Installation Guide
HDCAMJW Jeep Wrangler JK AHD Night Vision Backup Camera
Spare Tire Mount Camera
for 2007-2018 Jeep Wrangler JK
-
Remove the Phillips screw and washer from the camera, releasing the butterfly bracket.
-
Using the Phillips screw and washer attach the small bracket from the PHD-Mount to the camera.
-
Using two M3 x .50 screws and lock washers, attach the camera to the Camera Mounting Plate.
-
Using a M6 x 1 screw and lock washer, attach the Camera Mounting Plate to the Right Angle Bracket asshown.
|
---|--- -
5A. For most appliacations with stock/standard wheels, attach the camera bracket assembly to the Wheel Bracket using a M6 x 1 screw and lock washer.
For applications with larger wheels and/or off-center wheel openings, see step
5B. For larger wheels, attach the Riser Plate to the Wheel Bracket and attach the camera assembly to the Riser plate using M6 x 1 screws and lock washers.
-
Place the completed assembly on the tire carrier wheel studs and install the supplied push nut retainers on the wheel studs.
Replace the spare tire.
Position the camera as close to center as possible. This may require removing and rotating the wheel until a usable opening in the wheel is located at or near center and adjusting the pieces of the mount to achieve the desired view.
Once positioned, tighten all camera bracket hardware and
lug nuts.
Wiring Diagram
Technical Support:
email – support@aampglobal.com
tel – 1-800-477-2267
web – EchoMaster.com
EchoMaster is a Power Brand of AAMP Global.
15500 Lightwave Drive, Suite 202, Clearwater, Florida 33760