ECHOMASTER P-BUA-SILVERADO Wiring Harness for Backup Alarm Instruction Manual
- June 9, 2024
- Echomaster
Table of Contents
ECHOMASTER P-BUA-SILVERADO Wiring Harness for Backup Alarm
Thank you for purchasing the
P-BUA-SILVERADO
WHAT’S INCLUDED:
- Vehicle Specific Wire Harness (P-BUA-SILVERADO)
COMPATIBLE ACCESSORIES:
- 97dB Backup Alarm (BUA-97C)
- 97dB White Noise Backup Alarm (BUA-97WNC)
TOOLS REQUIRED
- 10mm Nut-setter
- Impact Drill
INSTALLATION
STEP 1:
Locate the OEM tail lamp connector that is below the truck
- The connector is to the left of the vehicle’s spare tire on the cross member
STEP 2:
Unplug the OEM connector
STEP 3:
Install the P-BUA-SILVERADO harness between the two OEM connectors
STEP 4:
Use an impact drill and 10mm nut-setter to install a compatible backup alarm
on the metal surface that is below the truck’s tail lamp cavity (just outside
and above the driver side frame rail).
Note: (2) 10mm TEK screws are provided with the compatible backup alarm
STEP 5:
- Plug the backup alarm connector into the mating connector on the P-BUA-SILVERADO harness
STEP 6:
Enter the Vehicle Settings menu through the driver’s information center
- Change the remote entry exterior lighting to “off”
- This will prevent the backup alarm from sounding when the vehicle is unlocked with the OEM keyless entry transmitter
STEP 7:
Test the backup alarm
Phone – 866-766-2267
E-Mail – [email protected]
EchoMaster is a Power Brand of AAMP Global
EchoMaster.com