ECHOMASTER 2014-2021 Ford Transit Connect Wiring Harness for Backup Alarm Instruction Manual

June 9, 2024
Echomaster

ECHOMASTER 2014-2021 Ford Transit Connect Wiring Harness for Backup Alarm

ECHOMASTER-2014-2021-Ford-Transit-Connect-Wiring-Harness-for-Backup-Alarm-
product

Thank you for purchasing the P-BUA-TRANSIT CONNECT.

WHAT’S INCLUDED

  • Vehicle Specific Wire Harness (P-BUA-TRANSIT CONNECT)

COMPATIBLE ACCESSORIES

  • 97dB Backup Alarm (BUA-97C)
  • 97dB White Noise Backup Alarm (BUA-97WNC)

TOOLS REQUIRED

ECHOMASTER-2014-2021-Ford-Transit-Connect-Wiring-Harness-
for-Backup-Alarm-fig-1

  1. 10mm Nut-setter
  2. Impact Drill
  3. Panel Removal Tool
  4. Fish Tape
  5. Knife

INSTALLATION INSTRUCTIONS

ECHOMASTER-2014-2021-Ford-Transit-Connect-
Wiring-Harness-for-Backup-Alarm-fig-2

  • STEP 1: Locate and disconnect the OEM tail lamp connector that is in the driver side rear corner of the vehicle.
  • STEP 2: Install the P-BUA-TRANSIT CONNECT harness between the OEM connectors.
  • STEP 3: Route the harness down the driver side rear corner cavity.ECHOMASTER-2014-2021-Ford-Transit-Connect-Wiring-Harness-for-Backup-Alarm-fig-4
  • STEP 4: Remove the pictured grommet, so that the harness may pass through. Use a fish tape to route the 2 pin connector of the harness down through the bottom of the rear corner cavity and below the vehicle
  • STEP 5: Use an impact drill and 10mm nut-setter to install a compatible backup alarm on the underside of the vehicle
    • Note: (2) 10mm TEK screws are provided with the compatible backup alarm
  • STEP 6: Plug the backup alarm connector into the mating connector on the P-BUA-TRANSIT CONNECT harness. Use a knife to make a small cut in the grommet before it is re-installed
  • STEP 7: Test the backup alarm.

CONTACT

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Echomaster User Manuals

Related Manuals