ECHOMASTER P-BUA-PROMASTER CITY Wiring Harness for Backup Alarm 2015-2020 Ram Promaster City Instruction Manual
- June 9, 2024
- Echomaster
Table of Contents
ECHOMASTER P-BUA-PROMASTER CITY Wiring Harness for Backup Alarm 2015-2020
Ram Promaster City
Thank you for purchasing the P-BUA-PROMASTER CITY
WHAT’S INCLUDED
- Vehicle Specific Wire Harness (P-BUA-PROMASTER CITY)
COMPATIBLE ACCESSORIES
- 97dB Backup Alarm (BUA-97C)
- 97dB White Noise Backup Alarm (BUA-97WNC)
TOOLS REQUIRED
- 10mm Nut-setter
-
3 Phillips Bit
- Impact Drill
INSTALLATION
STEP 1:
Use an impact drill and #3 Phillips bit to remove the driver-side tail lamp
assembly
STEP 2:
Unplug the OEM tail lamp connector and install the P-BUA-PROMASTER CITY
harness between the OEM connectors
STEP 3:
Route the harness down the tail lamp cavity and re-install the driver-side
tail lamp
Note: Make sure the in-line filter on the harness is tucked into the lamp housing as shown or the lamp will not fit back into place
STEP 4:
Use an impact drill and 10mm nut-setter to install a compatible backup alarm
on the underside of the vehicle
Note: (2) 10mm TEK screws are provided with the compatible backup alarm
STEP 5:
Plug the backup alarm connector into the mating connector on the P-BUA-
PROMASTER CITY harness.
STEP 6:
Test the backup alarm
Contact Information
Phone – 866-766-2267
E-Mail – support@aampglobal.com.
EchoMaster is a Power Brand of AAMP Global
EchoMaster.com.