Creality Sprite Extruder Pro Kit User Manual
- September 3, 2022
- Creality
Table of Contents
Sprite Extruder Pro Kit
User Manual
Parts List
Installation instructions
-
Remove the original hotend kit, and install the mounting backplane kit on the X-axis profile.
-
Select an appropriate slot on the mounting backplane according to timing belt length. Adjust the eccentric nut so that the mounting backplane kit slides freely on the X-axis profile without shaking.
-
Fix Sprite Extruder Pro on mounting backplane with 4pcs M3×6 hexagon round head screws.
Motherboard Wiring Diagram
-
Connect a terminal to the corresponding interface on the motherboard according to the cable label(Terminals without labels are redundant and do not need to be connected to the motherboard. Please disconnect printer power when wiring). Then connect the other end of the cable to Sprite Extruder Pro.
-
Adjust the printer’s Estep’s value to 424.9 (the value is for reference only and can be fine-tuned according to the actual printing situation), and then click “Store Settings”.
If the printer does not support adjusting the Esteps value to 424.9, you can make it with the following 4 steps.
-
Create a new text file (txt) and type “M92 E424.9” in the text.
-
Press “Enter” to continue typing “M500”.
-
Save the file as the code format, and copy it into the TF card.
-
Insert the TF card into the printer and click to print this file. At this time, the printer’s Estep’s value has been adjusted to 424.9.
-
After installation, you need to level the printing platform again.
-
The side adjusting screw on the Sprite Extruder Pro can adjust the clamping degree between extrusion gear and filament. Clockwise is for tightening and anticlockwise is for loosening.
3. The withdrawal distance must be less than 3mm.
If the 3D printer restarts during hotend heating up, please reverse the heating tube connectors on the mainboard.
Sprite Extruder Pro Kit Material Guide
Material| Printing with an enclosure recommended| Dry box recommended|
Retraction distance| Retraction speed| Heatbed temperature (+- 5°C)| Nozzle
temperature (+- 5°C)| Recommended printing speed
CR-PLA| NO| NO| 0.8mm| 40mm/s| 60℃| 200℃| 50mm/s
CR-TPU| NO| NO| 2mm| 40mm/s| 60℃| 230℃| 50mm/s
HP-TPU| NO| NO| 2mm| 40mm/s| 60℃| 210℃| 50mm/s
Retraction speed: 35-45 mm/s
Retraction distance (direct drive) for rigid materials (PLA): 0.8 mm
Retraction distance (direct drive) for soft materials (TPU-95): 2 mm
Caution:
- All wires must not be clamped during machine assembly;
- For parameter configuration and more advanced configurations, please refer to the official website: www.creality.com
The specific values of printing parameters need to be adjusted according to filaments of different manufacturers.
Leveling Tip
This paper can be used for manual leveling or auxiliary leveling. thickness
0.1mm.
Due to the differences between models, product images, and descriptions only for reference purposes, please see the subject produce. The final explanation rights shall be reserved by Shenzhen Creality 3D Technology Co., Ltd.
https://qr.creality.com
SHENZHEN CREALITY 3D TECHNOLOGY CO., LTD.
Add 18F, JinXiuHongDu Building, Meilong Blvd.,
Longhua Dist., Shenzhen, China 518131
Official Website: www.creality.com Tel: +86
755-8523 4565
E-mail: [email protected] [email protected]