i-box Stylus TT517-13 3 Speed Turntable User Guide

: June 13, 2024
: i-box

Table of Contents

Disclaimer
Troubleshooting
Specifications
Technical Support
Read User Manual Online (PDF format)
Download This Manual (PDF format)

i-box Stylus TT517-13 3 Speed Turntable User Guide

Pairing with Bluetooth Enabled Devices
To connect a compatible Bluetooth device, turn the Mode Speed selector switch to BT. The LED will flash blue and is ready to pair, look for “i-box Stylus N10 in your device’s Bluetooth menu. Connect your device, you will hear a multiple audio tone and the LED wil stop flashing and remain blue to confirm connection.

Pairing

For volume control adjust the volume on the N10 and on your Bluetooth device. Use the controls of your Bluetooth device for all other actions. Use your Bluetooth device’s menu to disconnect, you will hear a single audio tone to confirm =<3 disconnection and the LED will flash blue to indicate pairing mode is activated.

Auxiliary Input – AUX-IN

The 3.5mm AUX-IN Portis ideal for playback of audio from older mobile devices without Bluetooth capability. Connect your device to the AUX-IN port (19) with a 3.5mm stereo jack lead (not supplied). (] Power on the turntable and the auxiliary device, the LED will light up purple. &S Adjust the volume on the N1, Use the controls of your auxiliary device for all other actions.
Please Note: The AUX-IN function overrides all others no matter what the mode settings.

Care
See page 3 for general tips for cleaning the turntable and vinyl discs. The stylus will also need cleaning from time to time i only to remove fluff and dust, Use a proper stylus brush o cleaner only (not supplied. Clean the stylus tip by moving the brush from the rear to the front of the stylus tp.
Care

*Counterweight and Tracking Force Adjustment
** Loosen the lock screw before adjusting the counterweight.

Unclip the tonearm position the tonearm in the space between the tonearm rest and the platter.

Gently lower the tonearm lever, being careful not to damage the stylus, rotate the counterweight backwards and forwards so that the tonearm hangs level in a neutral balance position.
The tonearm when moved up and down should now return to this position.
Return the tonearm to the rest.
Hold the counterweight still and rotate the front Tracking Force Dial separately so that the “O” lines up with the line on the tonearm. Check the balance is still neutral.
Now rotate the counterweight and tracking force dial together, counter- clockwise to 3.5g (the recommended tracking force for the AT 3600L cartridge fittedcartrige).

*The tonearm counterweight has been factory preset for the AT 3600L cartridge fitted.

Replacing the Stylus
It is recommended to replace the stylus after 1,000 hours of playing time or f itis damaged. Swatch off the N10 and disconnect from the mains. When removing the old stylus, hold the stylus heads hell and the cartridge body tightly. Rotate the front of the stylus forward and then pull downwards to remove.
Replacing

To fit a new stylus, slot it onto the cartridge, then lift and rotate the stylus until it clicks into place
Replacing

Replacing the Belt
Over time the belt can deteriorate and stretch causing itto slip or cause juddering.
First switch off the N10 and disconnect from the mains.
A. Remove the felt mat. ® . Unhook the old belt from the drive pulley.

C. Remove the circlip holding the platter in place and liftoff the platter o
Replacing the Belt
D. Remove the old belt from the platter.

E. Place the new belt on the platter.

F. Hook the belt over the drive pulley making sure itis not twisted

G. Rotate the platter slowly 10xin a clockwise direction to seat the belt properly and make sure it turs smoothly.

Disclaimer

Updates to Firmware and/or hardware components are made regularly. Therefore some of the instructions, specifications and pictures in this documentation may differ slightly from your particular situation. Allitems described in this guide are for llustration purposes only and may not apply to your particular situation. No legal right or entitlements may be obtained from the description made in this manual.

Declaration of Conformity
Hereby, Phelix Electronic Ltd. declares that the radio equipment: model Stylus NIO Compact Turntable with Detachable Speaker for wireless reception in domestic premises is in compliance with the Radio Equipment Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.philex.com/doc

Troubleshooting

Problem	Possible cause	Solution
The unit does not respond or has cut out (no power)	Auto power OFF has
activated due to no input/activity.	Turn the power switch OFF and then ON

again
The power adaptor is not connected to the mains socket.| Connect to the mains socket.
The mains socket is not switched on or is defe8ctive.| Switch on the mains switch or try another socket.
Wrong source selected.| Select the correct source.
Device not turned ON.| Turn ON the device.
Volume set too low.| Turn the volume dial up to increase the sound level.
Sound is distorted| Volume level is set too high.| Decrease the volume.
Check the stylus for fluff| Remove fluff with stylus cleaner
The platter does spin or spins at varying speed| The belt may be misaligned or worn| Check belt alignment and condition realign
The LED is purple and a cable is connected to AUX IN| Disconnect AUX IN cable
Power is on, but LED is off the N10 may have Auto Powered off due to inactivity| Turn the power switch OFF and then ON again.
The stylus skips| Is the disc warped/damaged| Try playing a different disc
Is the stylus pressure correct?| See “Tracking Force Adjustment”