VIVO STAND-V001K Pneumatic Arm Single Monitor Desk Mount Instruction Manual

VIVO STAND-V001K Pneumatic Arm Single Monitor Desk Mount

WARNING!

If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.

TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:

• NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
• USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL
• USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIPOVER.

WARNING: CHOKING HAZARD

• SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.

PACKAGE CONTENTS

NOTE : SOME HARDWARE INCLUDED MAY NOT BE USED.

TOOLS NEEDED

DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.

ASSEMBLY STEPS

STEP 1
Loosen the bolts and disassemble the Clamp (D) using the 4mm Allen Wrench (T-A).

STEP 2

OPTION A: Clamp Installation
Attach Clamp Brace (D1) to Pole (B) using M6x16mm Screws (S-A) and 4mm Allen Wrench (T-A). Peel the protective film off of the Soft Pad (G) and place it onto the Clamp Brace (D1).

OPTION B: Grommet Base Installation
For grommet hole attachment only, cut the Soft Pad (G) along the indentations. Peel the protective film off of the Soft Pad (G) and place the pieces onto the Grommet Base (F) as shown below.

OPTION A: Clamp Installation
For thinner desktops, re-attach the Clamp (D2) to the Clamp brace (D1) and tighten the bolts using 4mm Allen Wrench (T-A). For thicker desktops, disassemble the clamp (D2) using a Phillips screwdriver as shown in 3.1. Flip the L-bracket over and reassemble. Then re-attach Clamp (D2) to Clamp brace (D1) and tighten the bolts using 4mm Allen Wrench (T-A).

OPTION B: Grommet Installation
If not using an existing through-hole, using a 10mm (⅜”) drill bit, drill through the desktop at least 2” away from the edge. Disassemble the Clamp (D2) using a Philips screwdriver. Set aside all parts except for Clamp Bolt (D3). Attach Pole (B) and Grommet Base (F) to the desktop using the Support Plate (H) and Clamp Bolt (D3) as shown below

STEP 3

Slide Arm (A) onto Pole (B) and tighten using 6mm Allen Wrench (T-B). Attach Cable Clip (E) to Pole (B).

STEP 4
Attach VESA Plate (C) to the back of the monitor using approproate Screws (M-A through M-D) and Washers (M-E). If needed, use Spacers (M-F).

STEP 5
Slide VESA Plate (C) with monitor over bracket on Arm (A). Secure using the Thumbscrew (I).

STEP 6
Adjust gas spring support in arm using 6mm Allen Wrench (T-B). Turning counter-clockwise increases support, and clockwise decreases.

STEP 7
Remove bottom cover from Arm (A) by sliding it off. Organize cables and re- attach cover.

STEP 8
Adjust tilt support using 6mm Allen Wrench (T-B). Store Allen Wrenches (T-A, T-B) in Cable Clip (E). Adjust as desired.

Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us

Open Monday – Friday 7:00am – 7:00pm CST,
our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product.

PHONE:309-278-5303
EMAIL:help@vivo-us.com

AVG. RESPONSE TIME (within office hrs): 1HR 8M

• 23% within < 15m
• 38% within < 30m
• 61% within < 1hr
• 83% within < 2hr
• 92% within < 3hr

FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo- us.com

Documents / Resources

| VIVO STAND-V001K Pneumatic Arm Single Monitor Desk Mount [pdf] Instruction Manual
STAND-V001K Pneumatic Arm Single Monitor Desk Mount, STAND-V001K, Pneumatic Arm Single Monitor Desk Mount, Arm Single Monitor Desk Mount, Single Monitor Desk Mount, Monitor Desk Mount, Desk Mount, Mount
---|---

References

• Register a .US.COM domain today!
• VIVO - Desks, Monitor Mounting, and More Home & Office Solutions – VIVO - desk solutions, screen mounting, and more
• Pneumatic Arm Single Monitor Desk Mount – VIVO - desk solutions, screen mounting, and more

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>