LEDOLUX 18W LED Downlight Instruction Manual
- June 13, 2024
- LEDOLUX
Table of Contents
LEDOLUX 18W LED Downlight
Product Information
- Product Name: DOWNLIGHT LED
- Power Options: 18W, 24W, 30W
- Dimensions (H): 85mm
- Weight: 0.4kg (18W, 24W), 0.6kg (30W)
- Nominal Voltage: 220 – 240V ~
- Frequency: 50 / 60Hz
- Colour Temperature: 4000K
- Luminous Efficacy: 105lm/W
- Mounting Height: 1 – 4m
Product Usage Instructions
- Before starting the installation, make sure to disconnect the power supply.
- Using a screwdriver, unscrew the screws and open the cover of the luminaire.
- Connect the luminaire to the power supply according to the wire marking below:
L Brzowy | Brown | Braun
N Niebieski | Blue | Blau 8mm 25mm
Note : The installation of the LED luminaire must be performed by a qualified person. If you have any doubts about the installation or use of the product, consult the manufacturer.
Instruction
| Ø| H| Waga
---|---|---|---
18W| 190mm| 85mm| 0.4kg
24W| 190mm| 85mm| 0.4kg
30W| 220mm| 85mm| 0.6kg
NOMINAL VOLTAGE|
---|---
220 – 240V ~
FREQUENCY|
50 / 60Hz
COLOUR TEMPERATURE|
4000K
LUMINOUS EFFICACY|
105lm/W
BEAM ANGLE|
90°
OPERATING TEMPERATURE|
-20°C ÷ +40°C
MOUNTING HEIGHT|
1 – 4m
NOTE
- Installation must be performed by a qualified person. In case of doubts as to the installation or use of the LED luminaire, consult manufacturer
- Replace the luminaire after a failure. Self-repair shall void the warranty.
- This product contains a light source with energy efficiency class E.
- Keep the luminaire in a cool, dry and clean environment. Keep away from water and fire.
- Make sure you disconnect the power supply before installation. Turn on the power after connecting and securing all luminaires in the circuit.
- The light source used in this luminaire should only be replaced by the manufacturer or their service representative, or a similarly qualified person.
- Protect your eyes, avoid looking at the light for a long period of time.
- Dirtiness that settle down on the luminaire due to normal operation shall be cleaned with a damp cloth. Do not use invasive cleaners or cleaning methods.
APPLICATION
- Office facilities
- Commercial facilities
- Public utility facilities
E-mail: [email protected] Tel: +48 696 966 622
Data: 03.03.2023
We reserve the right to make design changes to luminaires.
- Make sure you disconnect the power supply before installation.
STEPS
-
Cut a hole and pass the power cord through it.
| Cut size ****
---|---
18W| 165mm
24W| 165mm
30W| 195mm -
Using a screwdriver, unscrew the screws and open the cover. Connect the luminaire to the power supply according wire marking below.
-
Bend the spring upwards and install the luminaire in the hole.