LEDOLUX POLAND LED Light Microwave Intelligent LED Luminaire Instruction Manual
- June 13, 2024
- LEDOLUX POLAND
Table of Contents
POLAND LED Light Microwave Intelligent LED Luminaire
Instruction Manual
POLAND LED Light Microwave Intelligent LED Luminaire
PLAFON LED L &M
| Ø| H| Waga
---|---|---|---
22W| 300mm| 87mm| 1.0kg
NOMINAL VOLTAGE…………………………… 220 – 240V ~
FREQUENCY………………………………………… 50 / 60Hz
COLOUR TEMPERATURE………………………. 4000K
LUMINOUS EFFICACY…………………….. 90lm/W
BEAM ANGLE…………………………………….. 120°
OPERATING TEMPERATURE …………..-20°C ÷ +40°C
MOUNTING HEIGHT ……………………………….1 – 5m
Mounting
Make sure you disconnect the power supply before installation.
Unscrew the outer ring by turning it clockwise.
Remove the 4 screws holding the lampshade with a screwdriver (M4, 7Nm).
Pass the power cable (ø4-8mm) through the cable joint.
Connect the wires with the clamp as marked below.
Configure the parameters of the motion and dusk sensor.Close and assemble the lampshade.
Screw the metal bracket to the ceiling / wall.
Fix the luminaire on the holder, tighten the fixing screws with a screwdriver
(ø4.7Nm).
Motion and dusk sensor
Detection range | 180°/360°; 2-15m |
---|---|
Nominal voltage | 220-240V AC |
Frequency | 50/60Hz |
HF system | 5,8GHz CW radar, ISM band |
Rated load | 22W |
Hold time | 10s, 90s, 3min, 10min |
Standby time | 0s, 30s, 10min, +∞ |
Detection range Hold time – lighting time of the luminaire after the
disappearance of traffic. Dusk sensor – adjusting the sensitivity of the
sensor to light. Standby time – the time after the back up time in which the
luminaire remains dimmed (+ ∞ the luminaire will not turn off).
The lx level at the time of hold NOT INCLUDED
Use an IP66/IP68 cable
connector for connections
Number of terminals: 3
Rated voltage: max. 250V
Connectivity: 0.50-2.50mm2
Connecting the power cable
L…………. Brown
N……………… Blue
NOTE
Installation must be performed by a qualified person. In case of doubts as to
the installation or use of the LED luminaire, consult manufacturer.
Replace the luminaire after a failure.
Self-repair shall void the warranty.
This product contains a light source with energy efficiency class F.
Keep the luminaire in a cool, dry and clean environment. Keep away from water
and fire.
Make sure you disconnect the power supply before installation. Turn on the
power after connecting and securing all luminaires in the circuit.
The light source used in this luminaire should only be replaced by the
manufacturer or their service representative, or a similarly qualified person.
Protect your eyes, avoid looking at the light for a long period of time.
Dirtiness that settle down on the luminaire due to normal operation shall be
cleaned with a damp cloth. Do not use invasive cleaners or cleaning methods.
APPLICATION
- Office facilities
- Commercial facilities
- Public utility facilities
Ledolux Poland Sp. z o.o.
Ul. Innowacyjna 1
36-060 Głogów Małopolski
POLSKA
E-mail: info@ledolux.pl
Tel: +48 696 966 622
Data: 03.00.2023
We reserve the right to make design changes to luminaires.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>