VIVO MOUNT-VWSF1,W Wall Mount for 23 Inch to 55 Inch TVs Instruction Manual

June 13, 2024
Vivo

**VIVO MOUNT-VWSF1,W Wall Mount for 23 Inch to 55 Inch TVs Instruction Manual


**

WARNING!

If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.

PACKAGE CONTENTS

  • A (x1) Mount

  • B (x2) Plastic Cover

  • C (x1) Cable Clip

  • D (x4) VESA Adapter

  • E (x1) Shelf

  • F (x1) Shelf

  • G (x2) Shelf Clip
    Package Content

  • H (x2) Suction Cup

  • S-A (x4) M6x15

  • S-B (x2) M5x8mm Screw

  • S-C (x4) M6 Nut

  • M-A (x4) M6x14mm Screw

  • M-B (x4) M8x20mm Screw

  • M-C (x4) Spacer

  • W-A (x3) ST6x55mm Bolt

  • W-B (x3) Anchor

  • W-C (x1) M6 Washer

  • W-A2 (x3) ST6x55mm Bolt

  • W-B2 (x3) Anchor

  • W-C2 (x3) M6 Washer

NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED

CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us. com, email at help@vivo-us.com, or call us at 309-278-5303.

TOOLS NEEDED

Drill

Phillips Screwdriver

DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.

TV Mount

Shelf

WARNING: CHOKING HAZARD
SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.

TV MOUNT ASSEMBLY STEPS

STEP 1

OPTION A: Wood Wall
Use Mount (A) to mark mounting holes on wall where stud is located. Using a 3/16” bit, drill approximately 2.2” into marked locations. Screw two ST6x55mm Bolts (W-A) into top holes, making sure to leave 3mm of threads exposed.

OPTION B: Concrete/Brick Wall
Use Mount (A) to mark mounting holes on wall. Using a 3/8” bit, drill approximately 2.4” into marked locations. Insert Wall Anchors (W-B) and screw two ST6x55mm Bolts (W-A) into top holes, making sure to leave 3mm of threads exposed.

STEP 2
Mount VESA Adapters (D) to VESA Plate on Mount (A) using M6x15mm Screws (S-A) and M6 Nuts (S-C) in the appropriate configuration to match your television mounting holes.

STEP 3
After placing TV on a flat surface, attach VESA plate to back using Screws (M-A, M-B). Make sure top of mount is facing top of TV. If screws are too long, Spacers (M-C) may be required as shown in diagram.

STEP 4
Slide Mount (A) over two Screws (W-A) already inserted into wall and insert third 0ST6x55mm Screw (W-A) and M6 Washer (W-C) into bottom hole. Tighten using Phillips screwdriver.

STEP 5
Insert Plastic Covers (B) as shown in diagram.

STEP 6
Attach Cable Clip (C) to bottom of Mount (A).

STEP 7
Run cables through Cable Clip (C) and adjust monitor to desired angle as shown in diagram.

SHELF ASSEMBLY STEPS

STEP 1
OPTION A: Wood Wall
Using the Shelf Bracket (E) as a guide, mark the mounting holes on the wall where a stud is located. With a 4mm bit, drill approximately 2” into wall. Mount the Shelf Bracket (E) onto wall using ST6x55mm Bolts (W-A2) and M6 Washers (W-C2). Ensure the mounting screws are anchored into the center of the studs. The use of a stud finder is highly recommended.

STEP 1
OPTION B: Concrete/Brick Wall
Using Shelf Bracket (E) as a guide, mark mounting holes on wall. With a 5/16” bit, drill approximately 2.2” into wall. Insert Concrete Anchors (W-B2), ST6x55mm Bolts (W-A2) and M6 Washers (W-C2) to mount the Shelf Bracket (E) onto wall as shown in diagram.
Assembly Instruction

STEP 2
Insert Shelf Clips (G) into Shelf Bracket (E).

STEP 3
Attach Suction Cups (H) to Shelf Bracket (E) as shown in diagram.

STEP 4
Slide Shelf (F) into Clips (G).
Assembly Instruction

STEP 5
Use M5x8mm Screws (S-B) into Shelf Bracket (E) to secure the Shelf (F) into place using a Phillips screwdriver as shown in the diagram.

STEP 6
Place desired objects on shelf.
Assembly Instruction

Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us

Open MondayFriday 7:00am7:00pm CST,
our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product.

309-278-5303 AVG. RESOLUTION TIME (within office hrs): 5M 4S

 www.vivo-us.com AVG. RESOLUTION TIME (within office hrs): < 15 M Chat live with an agent!

 help@vivo-us.com
AVG. RESPONSE TIME (within office hrs): 1HR 8M
– 23% within < 15m
– 38% within < 30m
– 61% within < 1hr
– 83% within < 2hr
– 92% within < 3hr

FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo- us.com

Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product.
https://vivo-us.com/products/mount-vwsf1

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Vivo User Manuals

Related Manuals