PROJECTA EVAPT2T1 Type 2 To Type 1 Ev Adaptor Instructions

June 12, 2024
Projecta

PROJECTA-LOGO

PROJECTA EVAPT2T1 Type 2 To Type 1 Ev Adaptor

PROJECTA-EVAPT2T1-Type-2-To-Type-1-Ev-Adaptor-
PRODUCT

Product Information

  • P/No. EVAPT2T1
  • EV Adaptor
  • Type 2 to Type 1 Adaptor

For charging a Type 1 vehicle at a Type 2 charging station.

Specifications:

  • Part No.: EVAPT2T1
  • Rated Current: [insert rated current]
  • Rated Voltage: [insert rated voltage]
  • Ingress Protection: [insert ingress protection rating]
  • Voltage Withstand: [insert voltage withstand rating]
  • Flame-Retardant Cable Length: [insert cable length]
  • Working Temperature: [insert working temperature range]
  • T2 Inlet Socket Side
  • T1 Outlet Vehicle Side

Product Usage Instructions

  1. Connect the adaptor to the charging station.
  2. Plug your charging inlet lead to the adaptor.
  3. Connect the outlet of the charging lead to the car.
  4. To stop charging, follow the reverse procedure.

WARNING: [insert warning message]

CARE INSTRUCTIONS: [insert care instructions]

IMPORTANT NOTE:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement orrefund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Distributed by: AUSTRALIA Brown & Watson International Pty. Ltd. Knoxfield Victoria 3180 Phone: (03) 9730 6000Fax: (03) 9730 6050 National Toll Free: 1800 113 443 NEW ZEALAND OFFICE Griffiths Equipment Ltd. 19 Bell Avenue, Mount Wellington, Auckland 1060, New Zealand Phone: (09) 525 4575 IS532 Issue 1 3.3.23

WARNING

  • For charging EV Vehicles only.
  • If damaged do not attempt to use. It must be replaced or repaired by a qualified person.
  • This adaptor is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  • Children should be supervised to ensure that they do not play with the appliance.

CARE INSTRUCTIONS

  • Try and keep clean, avoid mud and harsh chemicals.
  • Clean cable and connector housing with mild detergent and water.
  • Apply lubricated contact cleaner to the power terminals regularly.

INSTRUCTIONS FOR USE

  1. Connect the adaptor to the charging station.
  2. Plug your charging inlet lead to the adaptor.
  3. Connect the outlet of the charging lead to the car.
  4. To stop charging. Follow the reverse procedure.

SPECIFICATIONS

PART NO. EVAPT2T1
RATED CURRENT 32A Max
RATED VOLTAGE 250V AC
INGRESS PROTECTION IP65
VOLTAGE WITHSTAND 2000V AC 5S
FLAME-RETARDANT UL94V-0
CABLE LENGTH 0.3m
WORKING TEMPERATURE -30°C ~ +50°C
  • T2 INLET
    Socket Side

  • T1 OUTLET
    Vehicle Side

PROJECTA-EVAPT2T1-Type-2-To-Type-1-Ev-Adaptor-FIG-1

WARRANTY STATEMENT
Brown & Watson International Pty Ltd (“BWI”) of 1500 Ferntree Gully Road, Knoxfield, Vic., telephone (03) 9730 6000, fax (03) 9730 6050, warrants that all products described in its current catalogue will under normal use and service be free of failures in material and workmanship for a period of one (1) year from the date of the original purchase by the customer as marked on the invoice. This warranty does not cover ordinary wear and tear, abuse, alteration of products or damage caused by the purchaser.

To make a warranty claim the consumer must deliver the product at their cost to the original place of purchase or to any other place which may be nominated by either BWI or the retailer from where the product was bought in order that the warranty assessment may be performed. The consumer must also deliver the original invoice evidencing the date and place of purchase together with an explanation in writing as to the nature of the claim.

In the event that the claim is determined to be for a minor failure of the product then BWI reserves the right to repair or replace it at its discretion. In the event that a major failure is determined the consumer will be entitled to a replacement or a refund as well as compensation for any other reasonably foreseeable loss or damage. This warranty is in addition to any other rights or remedies that the consumer may have under State or Federal legislation.

IMPORTANT NOTE
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Distributed by AUSTRALIA Brown & Watson International Pty. Ltd. Knoxfield Victoria 3180

  • Phone : (03) 9730 6000
  • Fax : (03) 9730 6050
  • National TollFree : 1800 113 443

NEW ZEALAND OFFICE Griffiths Equipment Ltd. 19 Bell Avenue, Mount Wellington, Auckland 1060, New Zealand

  • Phone : (09) 525 4575

IS532
Issue 1 3.3.23

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals