MaxxGarden 21027 Umbrella Heater User Manual

MaxxGarden 21027 Umbrella Heater

INSTRUCTIONS

When using electrical appliances, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, or injury to persons, including the following:
Read all instructions before using this heater

• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 0.9 m from the front of the heater.
• Extreme caution is necessary when any heater is used by or near children or invalids and when- ever the heater is left operating and unattended.
• Always unplug heater when not in use.
• Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
• This heater is not intended for use in bathrooms, laundry areas and similar locations. Never locate heater where it may fall into a bathtub or other water container.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
• Connect to properly grounded outlets only.
• To disconnect heater, turn controls off, then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
• Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
• Check if the voltage indicated on the nameplate of the appliance corresponds to the local mains voltage before you connect the appliance.
• The appliance is not located immediately below a wall socket-outlet.
• The casing and the front cover of the appliance become extremely hot during operation. Pay attention that, no combustible material due to wind or other environmental influences covers or obstructs the appliance, such as curtains, marquees, flags, plastic foil etc. Do not touch the appliance. Caution! Risk of scald injury!
• n case of improper use, there is a risk of electrical shock and/or fire hazard. Operation of the appliance must be discontinued and remove the mains plug immediately. Do not try to repair the appliance by your-self. Please contact with the service agent or a suitably qualified electrician for maintenance.
• Remove the plug from the power outlet and wait until the appliance is sufficiently cooled off before cleaning.
• Keep out of reach of children. In order to keep children from the dangers of electrical appliances, never leave them unsupervised with the machine. Consequently, when selecting the location for your machine, do so in such a way that children do not have access to the machine. Children being supervised not to play with the appliance.
• The appliance must only be mounted by an authorized specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations.

SAVE THESE INSTRUCTIONS

REMOTE CONTROL INSTRUCTIONS

OPERATION INSTRUCTION

• Remove all package material (including anti-vibration object of the lamp) and check the appliance, supply cord and the plug for signs of damage.
• Pay attention to the mounting place and all mounting material(dowels, screws). Ensure they are suitable and stable enough for mounting and lastingly holding of the appliance.
• Before mounting, the minimum safe mounting distances and tilt angles shown in the figures must be strictly followed.
• The distance between the bottom edge of the appliance and the floor must be at least 1.8 M. See figure 2.
• There must be a distance of at least 0.25 M between the appliance and the ceilings, roofs or other covers. See figure 2.
• There must be a distance of at least 0.5 M at each side between the appliance and walls or the like. See figure 2.
• Recommended degree to mounting surface is 45°. See figure 3.
• Pay attention that, the installation of the appliance must not add excessive wind load.
• Fix the mounting bracket to the ceiling l first. Ensure that the place to be installed is secure and firm. Or connect the appliance to the stand.
• Adjust the desired angle of radiation and fest screw all screws. Check regularly the screw’s connection. Mechanical bearing pressure and oscillation due to wind or rain could lead to loose.
• Plug in the power source and operate the remote control. Then observe, whether during the first 10-15 minutes the appliance works trouble-free.
• If you do not use,please remove battery socket

CLEANING AND MAINTENANCE

• This appliance is consist of a robust and maintenance-free aluminum casing with a protection cover. No user serviceable parts inside.
• Before cleaning,remove the plug from the power outlet and wait until the appliance is sufficiently cooled off.
• Wipe the appliance only with clean and lint-free cloth or a soft brush.
• Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning!
• Can use alcohol to clean the appliance.
• To protect against electrical shock and danger of life, do not immerse cord, plug, or any part of the appliance in water or other liquid.
• For heating element replacement, please contact the manufacturer or its service agent or a similarly qualified person.
• Any other service, please contact with the service agent or a suitably qualified electrician.

STORAGE
Do not route cord when heater storage, or heater is not in use.

CUSTOMER SERVICE

• Repairs must be carried out by authorized specialists, thus ensuring electrical safety.
• Please contact with the service agent or a suitably qualified electrician.
• Improper repairs could lead to danger to the user.
• This warranty does not cover damage of failure which results from alteration, accident, misuse, abuse, neglect, commercial use or improper maintenance.
• In line with our policy of continuous product development we reserve the right to change the product and documentation specifications without notice.

DISPOSAL
In accordance with European Directive 2011/65/EU concerning used electrical and electronic appliances (waste electrical and electronic equipment – WEEE), please return any electrical equipment that you will no longer use to the collection points provided for their disposal. This symbol indicates that the appliance cannot be treated as normal domestic trash, but must be handed to a collection point for recycling electric and electronic appliances. Information concerning where the equipment can be disposed of can be obtained from your local authority.

References

• Home - maxxtools.be

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>