MONOPRICE 44882 True Wireless Earphones User Guide

June 12, 2024
Monoprice

MONOPRICE logo TRUE WIRELES EARPHONES
44882
QUICK START GUIDEMONOPRICE 44882 True Wireless
Earphones

Contents

MONOPRICE 44882 True Wireless Earphones - fig 1MONOPRICE 44882 True Wireless Earphones - fig
2

Auto Pairing

MONOPRICE 44882 True Wireless Earphones - fig 3

Power ON/OFF

MONOPRICE 44882 True Wireless Earphones - fig 4Or when earphones are out of charging case

| Power on| | (L)(R)x 4sec
---|---|---|---
| Power off| | (L)/(R)x 10sec

  • Earphones will turn off automatically in 10 mins when did not connect to any device.

Voice assistant

Switch mode

MONOPRICE 44882 True Wireless Earphones - fig 6

Switch device

MONOPRICE 44882 True Wireless Earphones - fig 7 Call

| Receive an incoming call| | (L)/ (R) x 1
---|---|---|---
| Hang up the call| | (L)/ (R) x 1
| Reject Call| | (L)/ (R) x 2sec

Music

| Play music| | (L)/ (R)  x 1
---|---|---|---
| Pause music| | (L)/ (R)  x 1
| Previous Song| | (L)  x 3
| Next  Song| | (R)  x 3
| Low Down Vol| | (L)  x 2
| Add Up Vol| | (R)  x 2

*Long press operation:* When the long press time is up, you need to release in time to activate the corresponding function. (except for power on/off operation)
Mono earphone: Take out either one side from the charging case and follow the steps to connect and control. Ensure the other earphone in charging case and close the cover securely.
Reset**MONOPRICE 44882 True Wireless Earphones - fig
8 While both earphones are charging, press and hold the L and R MFB button for 10 s until the white lights flash. Then take out both eraphones, they will power on and enter pairing mode, which is available for new device connections.

Charging

MONOPRICE 44882 True Wireless Earphones - fig 9

Battery Level LED Indictor
0%~35% Orange light flashing
35%~70% White light flashing
70%~99% Green light flashing
100% Green light on

Specifications

Bluetooth Version V5.3
Bluetooth Profile A2DP/AVRCP/HFP/HSP/TMAP/PBP
Audio Decodec aptX lossless audio
Frequency Range 20Hz-20KHz
Distance ≥10m
Driver 10mm
Sensitivity 104 ± 2dB
Impedance 32Ω ± 15%
Battery Capacity 40mAh 3.7V (each earphone),
Input DC 5V / 1A
Ouput DC 5V / 340mA (Max)
Working Temperature -10℃~ +55℃

WARNING
DO NOT use alcohol, paint thinners, detergent, shampoo, or other solvents for cleaning purposes.
DO NOT intentionally immerse the earphones under water.
DO NOT wash the earphones in washing machine.
DO NOT expose the product to extremely high or low temperatures.
DO NOT leave the product near candles, cooking burners and open flames.
DO NOT disassemble the product in any way to avoid electric shock.
Only charge the battery in accordance to the instructions provided by the company.
DO NOT wash the charging box.
CAUTION
You must charge the earphone if it has not been used for more than 3 months.
Risk of explosion increases if battery is replaced by an incorrect type.
Dispose used batteries according to the instructions.
INSTRUCTIONS
Do not discard the used batteries along with household waste.
Disposal of battery should comply with local environmental regulations.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

IC Warning

This device complies with Industry Canada’ s licence-exempt
RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that maycause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
The device has been evaluated to meet general RF exposure requirement
The device can be used in portable exposure condition without restriction

MONOPRICE logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Monoprice User Manuals

Related Manuals