MBRP T5154 Exhaust Tip 6 Inch O.D. Angled Rolled End Installation Guide
- June 12, 2024
- MBRP
Table of Contents
T5154
2015-UP CHEV/GMC 2500/3500 DURAMAX, 5″-6″ ANGLED ROLLED END TIP
PLEASE READ BEFORE STARTING INSTALLATION
MBRP Inc. has made every effort to ensure that this component is of
superior quality and properly packaged. It is the installer’s responsibility
to ensure that the component is complete, including any additional hardware
and that it is undamaged. This should be done prior to the removal of factory
components. Finally, check that this system properly matches the make and
model of the vehicle and will not interfere with previous or planned
modifications.
Installation Instructions:
- Mark around the stock tail pipe 3” from the end of the vent. Refer to Figure 1.
- Cut the stock tail pipe off using a reciprocating saw (make sure cut is straight all the way around). File off burrs or sharp edges.
- Install Tip on the stock tail pipe. Rotate to desired position (use a level if necessary). Tighten Exhaust Tip. Refer to Figure 2.
Congratulations!
You are ready to begin enjoying your new visually appealing MBRP Exhaust
Tip.
We know you will enjoy your purchase.
T5154 © 11/21
Documents / Resources
| MBRP
T5154 Exhaust Tip 6 Inch O.D. Angled Rolled
End
[pdf] Installation Guide
T5154 Exhaust Tip 6 Inch O.D. Angled Rolled End, T5154, Exhaust Tip 6 Inch
O.D. Angled Rolled End, 6 Inch O.D. Angled Rolled End, Angled Rolled End,
Rolled End, End
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>