C-LITE C-TR-C-FP-SCCT LED Selectable Flat Panel Instruction Manual

June 4, 2024
C-LITE

INSTALLATION INSTRUCTIONS
C-LITE Backlit LED Flat Panel
With Selectable CCT and Wattage
C-TR-C-FP-SCCT LED Selectable Flat Panel
Instruction Manual

C-TR-C-FP-SCCT LED Selectable Flat Panel

C-LITE C-TR-C-FP-SCCT LED
Selectable Flat Panel - fig 1

CAUTIONS

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

  1. DANGER – Risk of shock- Disconnect power before installation.
  2. CAUTION – Risk of Fire.
  3. This luminaire must be installed in accordance with the NEC or your local electrical code. If you are not familiar with these codes and requirements, consult a qualified electrician
  4. Suitable for damp locations.
  5. ACCESS ABOVE THE CEILING IS REQUIRED. ACCES REQUIS AU-DESSUS DU PLAFOND.
  6. INHERENTLY PROTECTED.
  7. TYPE IC. The vapor barrier must be suitable for 90°C.
  8. FOR USE IN NON-FIRE-RATED INSTALLATIONS ONLY.
  9. NO USER-SERVICEABLE PARTS.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

Document: LPN00701X0001A0_B   Date  8-25-2021
Created By: TMT

INSTALLATION

  1. Locate desired fixture located in the ceiling grid.
  2. Remove the existing ceiling panel at the chosen location. Remove adjacent ceiling panels to allow for wiring access from above.
  3. Place fixture into T-bar ceiling grid. Bend clips on top of the fixture up and rotate out to engage with the T-bar support grid. Se e Figure 1. Secure fixture to grid in compliance with state and local codes.
  4. Remove the screw on the driver wiring chamber, disengage the retention spring clip, and remove the cover. Set screw and cover aside to be reinstalled later.
  5. Remove appropriate 1/2″ knockout(s) to allow for entry of supply wiring into the wiring chamber.
  6. Make wiring connections per the Fixture Wiring section.
  7. Reattach the cover of the wiring chamber with a screw that was removed in Step 4 above.
  8. Select the desired CCT and wattage using the dip switch on the top of the driver enclosure. See Figure 2.
  9. Replace the adjacent ceiling panel removed in Step 2.

C-LITE C-TR-C-FP-SCCT LED Selectable Flat Panel - fig
1C-LITE C-TR-C-FP-SCCT LED Selectable Flat
Panel - fig 1

http://lighting.cree.com/warranty
1-800-236-6800

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

C-LITE User Manuals

Related Manuals