HYUNDAI Sensor for Weather Stations Instruction Manual
- June 4, 2024
- HYUNDAI
Table of Contents
HYUNDAI Sensor for Weather Stations
PRECAUTIONS
- Avoid placing the clock near interference sources/metal frames such as computers or TV sets.
- The outdoor sensor must not be set up and installed underwater. Set it up in a way from direct sunlight and Rain
- Never clean the device using abrasive or corrosive materials or products. Abrasive cleaning agents may scratch plastic parts and corrode electronic circuits
- Do not clean any part of the product with benzene, thinner, or other solvent chemicals. When necessary, clean it with a soft cloth.
- Never immerse the product in water. This will damage the product.
- Do not subject the product to extreme force, shock, or fluctuations in temperature or humidity.
- Do not tamper with the internal components.
- Do not mix new and old batteries or batteries of different types.
- Do not mix alkaline, standard or rechargeable batteries with this product.
- Remove the batteries if storing this product for a long period of time.
- Do not dispose of this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary.
OUTDOOR SENSOR
-
Hanger
For easy placement -
TX Button
-
Battery Compartment
-
Channel Switch
-
Battery Compartment Cover
-
Wireless Signal Indicator
Flashes when data is being sent to the display unit
- 1 A. TX Switch – Set to match display unit
- 2 B. Install Batteries 2 AA batteries
Set the TX Switch
The TX switch is located inside the battery compartment.It can be set to 1, 2 or 3.
Install or Replace Batteries
Recommends high-quality alkaline or lithium batteries for the best product performance. Heavy-duty or rechargeable batteries are not recommended. The sensor requires lithium batteries in low-temperature conditions. Cold temperatures can cause alkaline batteries to function improperly. Use lithium batteries in the sensor for temperatures below -4 ºF / -20 ºC.
- Slide off the battery compartment cover. Take note of the 1-2-3 switch setting inside the battery compartment.
- Insert 2 x AA batteries into the battery compartment, as shown. Follow the polarity (+/-) diagram in the battery compartment.
Wireless Outdoor Sensor: 433 MHz RF transmitting frequency; ERP 0,04 mW
WE RESERVE THE RIGHT TO CHANGE TECHNICAL SPECIFICATIONS.
To avoid the danger of suffocation, keep the plastic bag away from babies
And children. Do not use this bag in cribs, beds, carriages, or playpens. This
bag is not a toy.
Disposal of old Electrical & Electronic Equipment (Applicable in the
European Union and other European countries with separate collection systems)
This symbol on the product or on its packaging indicates that this product
shall not be treated as household waste. Instead, it shall be handed over to
the applicable collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this
product. The recycling of materials will help to conserve natural resources.
For more detailed information about recycling of this product, please contact
your local Civic Office, your household waste disposal service or the shop
where you purchased the product.
Hereby, ETA a.s. declares that the radio equipment type WSSENZOR823 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www .hyundai-electronics.cz/declaration_of_conformity.
Licensed by Hyundai Corporation Holdings, Korea
Imported by ETA a. s., náměstí Práce 2523, 760 01 Zlín, CZ.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>