OzSpy DCELLHUNTER01 2G or 3G/4G Cell Phone Detector User Manual
- June 12, 2024
- OzSpy
Table of Contents
OzSpy DCELLHUNTER01 2G or 3G/4G Cell Phone Detector User Manual
Thank you for purchasing 1be Suresafe'” 2G & 3G Cell Phone De1ec1or. Please firs! read O\’er 1his manual for proper use. save !his manual and keep ii handy.
GENERAL
This device is made for detecting 2G cell phones radio waves in a & 3G place. This device also can detect wireless camera from 50 MHz – 6.0 GHz.
This device is special designed insensitive with 2-way raido. So, it will not be interfered with 2-way radio easily. This feature makes this device well suited to use in the places not allowed for cellphone communication, yet the security person communicate via 2-way radio.
It has network indication (LED) of 2G/Camera & 3G individually to show the type of detected radio waves.
When detected radio wave. the network indicator (LED) will blink in red. This device has sensitivity tuner for 2G/Camera & 3G individually for adjusting the sensitivity and the detection distance.
This device has built-in rechargeable battery that can last for 4 hours continuous use. When battery power runs down, the battery low warning indication will light up in red to warn the user.
HOW TO OPERATE
- Press down the On-Off switch and the power indicator in the front side will light up in green.
- Then unbend the antennas, please always keep the antennas in vertical straight for better result.
- Please be noted that the sensitivity adjustment of 2G/Camera & 3G are different.
Setting the sensitivity level of 2G/Camera:
1. Turn the sensitivity tuner to + (plus) side until the first yellow LED light up.
2. Turn the sensitivity tuner to -(minus) side to let the yellow LED put out.
Note: Over sensitive or too low sensitive setting should affect the detection ability.
Setting the sensitivity level of 3G:
Turn the sensitivity tuner to+ (plus) side at the maximum place. If one or two LEDs (sensitive level indicator) light up, this is OK.
DETECTING INDICATION
2G/Camera detecting indication:
This picture shows this device detects 2G/Camera radio wave, the network
indicator of 2G/Camera is blinking in red.
And the 3 LEDs of 2G/Camera sensitive level indicator light up.
3G detecting indication:
This picture shows this device detects 3G radio wave, the network indicator of
3G is blinking in red.
And the 3 LEDs of 3G sensitive level indicator light up.
When detect the cell phone radio wave, you can reduce the sensitivity level gradually to approach the signal source.
BATTERY LOW WARNING
There is a battery low warning indication on the front side. When battery runs down, the battery low warning LED will light up in red. Please connect the battery charger to charge the battery.
SILENT DETECTION
There is an earphone jack in the right side of front view. Connect the earphone to detect by earphone hearing.
ABOUT BATTERY
1. When the battery low warning LED light up in red. Connect the switching
power adaptor to continue the detecting and to recharge the battery at the
same time.
2. It will take about 7 hours to full charge the battery under POWER OFF
condition. If recharge under POWER ON condition, it will take about 16 hours
to full charge the battery.
3. If you are not going to use this device for a long time, please set the
On/Off switch at Off and check the battery power once three months.
4. Always use the battery charger supplied by the manufacturer to avoid any damage to the rechargeable battery. This device can be used during charging.
NOTICE OF USE
1. Never remove or change the antenna.
2. Unauthorized repair or dismantle of this device will void all the
warranties.
3. Avoid water.
4. Do not store this device in an excessively hot place.
5. Avoid knocks or dropping this device.
SPECIFICATION
Power| 1. Built-in rechargeable battery
2. Switching power adaptor
---|---
Battery life| About 4 hours after full charge
Detecting frequency band| 1. 2G: GSM
2. CDMA
3. 3G: WCOMA 2100 (UMTS)
Detecting distance| 1. 3G (WCDMA) : up to 15 meters
2. GSM : up to 20 meters
3. CDMA : up to 15 meters
Dimension| L 150 x W 80 x T 30 mm
Weight| About 310 g
Warning mode| 1 . Visible and audible alarm
2. Visible alarm. silent via earphone
Operation temperature| 0 – 40 centigrade
Humidity| 5% ~80%
- Spec1ficataons may change without notice
WARNING
Uae this device as an auxiliary, supplemental help or aid lo prevent the risks caused by hidden camera, cellular phone or other wireless devices. This device does not take the place of all the supervisions. Perlormance of thla Radio frequency (FIF} product will be affected by the circumstance of use. The producer and marketing group accepts no liability for any toss or damage by malfunction or misuse.
COPYRIGHT
No part ct lhls manual may be reproduced, transmitted, trall5Cribed, or translated into any language In any fonn by any means, ?ectrical or mechanical. including photocopying, recording, or information and retrieval systems, wilhoul the e,cpress written permission of manufacturer Products mentioned in this rmnual ar e for ldenbhcatlon purposes only. All brand names appeanng ,n th•• manual moy or may not be registered trademarks or copynghts of their respectrve companies. Th e manubcturer reserves the right to change or modify the specifications of any one or an ol these products as deemed necessary at any time without pnor notrficobon. The manufacturer may turther revise thi5 manual from time to time without prior notice.
Copyright 2000-2012, All rights reserved.
Made in Taiwan CE
11.2012
OzSpy DCELLHUNTER01 2G or 3G/4G Cell Phone Detector User Manual – [Download PDF]
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>