FORENEX FR-48522W Breakout Board Installation Guide

June 12, 2024
FORENEX

FR-48522
(RS422/ 485) Breakout Board
Quick Install Guide (QIG) Preliminary

General Description

Making UART-TTL logical level convert to RS422/ RS485

Feature:

UART-TTL with 3.3V/ 5V tolerance input.
An optional 120 Ohm (Terminate Resistor) built on board.
RoHS Compliant.

Ordering Information:
FR-48522W: with wire to board connector.
FR-48522D: with board to board Header.
WC7067060153: 6-pin to 6-pin, wire cable for input, L=150mm.

Connector:

UART-TTL Connector

UART3: (Wafer-6pin, 1.25mm, 90°) FR-48522W only| JP3: (Header-5pin, 2.0mm, 180°) FR-48522D only
|
Pin num.| Description| I/O| Pin num| Description| I/O
Pint| Power Input (3.3V/ 5V)| P| Pint| Power Input (3.3V/ 5V)| P
Pin2| UART-TX| I| Pin2| UART-TX| I
Pin3| UART-RX| 0| Pin3| UART-RX| 0
Pin4| GND| P| Pin4| GND| P
Pin5| UART-RTS| I| Pin5| UART-RTS| I
Pin6| NC| | | |

  • The UART-RTS is a data-flow direction control pin, only available as FR-48522 is set to RS485mode. Driving the UART-RTS to low will receive data from FR-48522.

FORENEX FR-48522W Breakout Board - FR

Terminate Resister Jumper: (Header-2x2pin, 2.0mm, 180°)

Pin| Description
AY/BZ side| Set terminate resister for the output of RS422 or RS485.
A/B side| Set terminate resister for the input channel of RS422 only.

FORENEX FR-48522W Breakout Board - RS422mode

Terminal Block Connector: (5-pin, Male, 90°)

Pin num.| Symbol| Jumper(J-RX) set on 422 side| Jumper(J-RX) set on 485 side
RS422 mode| RS485 mode
Description| I/O| Description| I/O
Pint| GND| Ground| | Ground|
Pin2| AY| Output Channel+| 0| In/Out Channel+| I/O
Pin3| BZ| Output Channel-| 0| In/Out Channel-| I/O
Pin4| A| Input Channel+| I| NC|
Pin5| B| Input Channel-| I| NC|

Dimension:

FORENEX FR-48522W Breakout Board - Dimension

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals