Samsung Electronics A035GDSN phone with Bluetooth User Guide
- June 5, 2024
- Samsung Electronics
Table of Contents
QUICK START GUIDE
SM-A035G/DSN
Package contents
- Device
- Ejection pin
- USB cable
- USB power adaptor
- Quick start guide
The items supplied with the device and their images may vary by region.
Device layout
To turn on the device, press and hold the Side key for a few seconds.
The charger should remain close to the electric socket and easily accessible while charging.
Installing a nano-SIM card
- Nano-SIM cards are sold separately.
- Support for single SIM and dual SIM models may vary by region.
Safety information
Read all safety information before using the device to ensure safe and proper use. You can view more safety information in the safety information menu of the Settings app.
Warning
Follow the warnings below to prevent incidents, such as fires or explosions,
injuries, or damage to the device
- Do not expose the device to physical impact or damage.
- Use only Samsung-approved batteries, chargers, and cables specifically designed for your device.
- Prevent the multipurpose jack and battery terminals from coming into contact with foreign materials such as metal, liquids, or dust.
- If any part of the device, such as the glass or acrylic body, is broken, smokes, or emits a burning odor, stop using the device immediately. Use the device again only after it has been repaired at a Samsung Service Center.
- Do not turn on or use the device when the battery compartment is exposed.
- Do not disassemble or reuse the battery.
- Do not allow children or animals to chew or suck the device.
- The device can be used in locations with an ambient temperature of 0 °C to 35 °C. You can store the device at an ambient temperature of -20 °C to 50 °C. Using or storing the device outside of the recommended temperature ranges may damage the device or reduce the battery’s lifespan.
- Do not use your device in a hot environment or near a fire.
- Comply with all safety warnings and regulations regarding mobile device usage while operating a vehicle.
You can download and install the firmware update to upgrade your device’s software with the firmware over-the-air (FOTA) service. To check for the firmware update, launch the Settings app and tap Software update → Download and install.
Specific Absorption Rate (SAR) certification information
Your device conforms to U.S. Federal Communications Commission (FCC) standards
that limit human exposure to radio frequency (RF) energy emitted by radio and
telecommunications equipment. These standards prevent the sale of mobile
devices that exceed a maximum exposure level (known as the Specific Absorption
Rate, or SAR) of
1.6 W/kg.
In normal use, the actual SAR is likely to be much lower, as the device has
been designed to emit only the RF energy necessary to transmit a signal to the
nearest base station. By automatically emitting lower levels when possible,
your device reduces your overall exposure to RF energy.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The FCC has granted an Equipment Authorization for this model device based on
the compliance of all reported SAR levels with the FCC RF exposure guidelines.
Some devices are required to receive approval from the FCC. If your device
required FCC approval, you can view the FCC certification by opening Settings
→ About phone → Status.
SAR information for this and other devices can be found on the FCC website
at: www.fcc.gov/oet/ea/.
Follow the instructions on the website to use the FCC ID to find SAR values
for the device.
SAR information for this device can also be found on Samsung’s website:
www.samsung.com/sar.
If your device is frozen and unresponsive, press and hold the Side key and the
Volume Down key simultaneously for more than 7 seconds to restart it.
The actual available capacity of the internal memory is less than the
specified capacity because the operating system and default apps occupy part
of the memory. The available capacity may change when you upgrade the device.
It is recommended not to use fixed graphics on part or all of the touchscreen
for extended periods. Doing so may result in afterimages (screen burn-in) or
ghosting.
To prevent possible hearing damage when using a headset, do not listen to sound at high volume for long periods.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Responsible party – U.S. Contact Information Samsung Electronics America, Inc.
QA Lab America 19 Chapin Rd. Building D, Pine Brook NJ 07058
Tel: 1-973-808-6375
Fax: 1-973-808-6361
FCC Notice
The device may cause TV or radio interference if used in close proximity to
receiving equipment. The FCC can require you to stop using the mobile device
if such
interference cannot be eliminated.
Information about the RF exposure from FCC
In August 1996, the Federal Communications Commission (FCC) of the United
States, with its action in Report and Order FCC 96-326, adopted an updated
safety standard for human exposure to radio frequency (RF) electromagnetic
energy emitted by FCC regulated transmitters. Those guidelines are consistent
with the safety standard previously set by both international and U.S.
standards. The design of this phone complies with FCC guidelines and these
international standards.
Body effects
For body operation, this device has been tested and meets FCC RF exposure
guidelines when used with any accessory that contains no metal and which
provides a minimum
separation distance of 15mm between this device and the body of the user. The
use of other accessories may not ensure compliance with FCC RF exposure
guidelines. The use of other accessories may not ensure compliance with FCC RF
exposure guidelines.
Class B Compliance under article 15 of the FCC This device complies with Part
15 of the FCC Rules. Operation is subject to the condition that this device
does not cause harmful interference. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
Caution
The user is cautioned that changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
Some content may differ from your device depending on the region, service
provider, or software version, and is subject to change without prior notice.
Copyright © 2020 Samsung Electronics Co., Ltd.
Printed in Korea
JM20-A035-B001 Rev.1.0
English (LTN). 10/2020
Visit www.samsung.com to view device
information, the user manual, and more.
You may incur additional charges for accessing the Internet.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>